APC CTFLE - Manuals - manualsarea.com

Page 3 - Chapter 1 General Information; Safety; Do not work alone under hazardous conditions.

1 Chapter 1 General Information The CTFLE Series Metered Power Supply Enclosure provides a power source for broadband cable operations. The enclosure is designed for mounting on the ground. Safety This Safety Guide contains important instructions that should be followed during installation and maint...

Page 4 - Specifications; Environmental Specifications

2 Specifications Environmental Specifications Operating Temperature -40º F to 140º F (-40º C to 60º C) Humidity 5% to 95% noncondensing within enclosure Physical Specifications Characteristic Specification Height X Width X Depth CTFLEH150 CTFLEH500 36” x 9.5” x 11” (91cm x 24 cm x 28 cm) 50” x 9.5” ...

Page 5 - Chapter 2 Installation and Maintenance; Unpacking; Models Supported; CTFLE Enclosure Installation; Ensure the utility circuit breaker is OFF.

3 Chapter 2 Installation and Maintenance Only trained service personnel should install and maintain the power supply. Prior to installation, utility line voltage must be routed to the enclosure. Local, state, federal and/or National Electric Code (NEC) regulations regarding location, permits and ele...

Page 7 - Wiring; Install an approved 20 A high-magnetic utility circuit breaker.; Connect the CTFLM

5 Wiring Install an approved 20 A high-magnetic utility circuit breaker. 1. Refer to the diagram below for wiring details. • Connect the black and white wires from the incoming utility line. • Route the power feed coax to the bottom of the enclosure and attach to the coax cable adapter using a pin c...

Page 8 - Chapter 3 Troubleshooting and Maintenance; Troubleshooting Power Supply Failure; to Initial Startup

6 Chapter 3 Troubleshooting and Maintenance Troubleshooting Power Supply Failure Problem Possible Cause Solution No input voltage detected at connector J1, pins 1 and 2. Replace the wiring harness Input voltage present at connector J1, pins 1 and 2. Disconnect power from the supply No input voltage ...

Page 9 - Routine Maintenance Procedures; Visual Inspection; Replacement Procedures; Wiring Harness Replacement

7 Routine Maintenance Procedures • Visual Inspection • Check external surfaces, connectors, indicators and wiring/cable assemblies for signs of dirt, wear, and damage. • Cleaning • Brush dust from controls and receptacles using a small paintbrush. • Wipe surfaces with clean, dry cheesecloth. • Clean...

Page 10 - Indicator Lamp Replacement; Initial Startup

8 • Reinstall the CTFLM. Ensure the module is seated properly. • Switch the CTFLM and the utility circuit breakers ON. • Complete Performance Verification. Refer to Initial Startup in this manual. • Replace the top door of the enclosure. • Indicator Lamp Replacement Gently pry the lens off the indic...

Page 11 - Chapter 4 Service, Contact and Warranty Information; Service; Support

9 Chapter 4 Service, Contact and Warranty Information Service APC makes every effort to ensure parts and equipment arrive in working condition. Occasionally, it may be necessary to return parts or equipment that are not in working condition. If the unit requires service do not return it to the deale...