Bosch DX4010I – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Page 6 – Settings; Refer to Figure 6 for jumper pin settings.
Page 7 – Address DIP Switches; Refer to Figure 7 for proper DIP switch orientation.; Address DIP switches; Programming; Set the address DIP switches to
Page 10 – DTE; The DX4010i serial port is wired as a DTE device.
Page 11 – Figure 9: P3 Connector
Loading the manual
EN
Installation Instructions
RS-232 Serial Interface Module
DX4010i
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
DX4010i | Installation Instructions | Trademarks 2 Bosch Security Systems, Inc. | 1/05 | 4998141106C Trademarks • BlackBox® is either a registered trademark or a trademark of BlackBox Corporation in the United States and/or other countries.
DX4010i | Installation Instructions | 1.0 General Information 4 Bosch Security Systems, Inc. | 1/05 | 4998141106C 1.0 General Information The DX4010i is a data terminal equipment (DTE) configured RS-232 serial device interface (SDI) module designed to operate with compatible control panels. It conne...
Page 6 - Settings; Refer to Figure 6 for jumper pin settings.
Page 7 - Address DIP Switches; Refer to Figure 7 for proper DIP switch orientation.; Address DIP switches; Programming; Set the address DIP switches to
DX4010i | Installation Instructions | 6.0 Remote Programming Direct Connection Bosch Security Systems, Inc. | 1/05 | 4998141106C 7 5.3 Address DIP Switches The address DIP switches are used to assign an address to the DX4010i. Refer to Table 3 for DIP switch option bus address settings. Refer to Tab...
Page 10 - DTE; The DX4010i serial port is wired as a DTE device.
DX4010i | Installation Instructions | 7.0 DB9 DTE RS-232 Connector (P6) 10 Bosch Security Systems, Inc. | 1/05 | 4998141106C 7.0 DB9 DTE RS-232 Connector (P6) The DX4010i serial port is wired as a DTE device. • If the connected device is a data carrier equipment (DCE) device (most common, such as an...
Page 11 - Figure 9: P3 Connector
DX4010i | Installation Instructions | 8.0 RJ-16 Data Bus Connector (P3) Bosch Security Systems, Inc. | 1/05 | 4998141106C 11 8.0 RJ-16 Data Bus Connector (P3) Figure 9: P3 Connector SER Rx Tx BUS Rx Tx LED ENABLE DB9 GND ENABLE P1 P6 P2 P3 1 1- RJ-16 data bus connector (P3) For remote programming co...