Bogen OCS1 - Manual
Bogen OCS1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Product Diagrams; . Coaxial Driver Assembly
- Page 4 – Installation; IMPORTANT
- Page 5 – Speaker Phasing
- Page 6 – Selecting Power Levels; Systems; Speaker Grille Installation & Removal
- Page 7 – Specifications
- Page 8 – Accessories; Limited Warranty
© 2003 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2089-0
1
B 0406
Orbit Ceiling Speaker
OCS1
Installation and Use Manual
54-2089-01B.qxp 6/18/2004 10:30 AM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Product Diagrams OCS 1 Front Drawing (grille removed) 1 . Coaxial Driver Assembly 2. Bass Tuning Vents (x2) 3. Grille Retention Groove 4. Power Tap Selection Switch 5. Mounting Clamp Screws (x4) OCS 1 Rear Drawing 6. Metal Back Can 7. Snap-Lock Input Connector 8. Mounting Clamps (x4) OCS 1 Rear Draw...
Installation The OCS 1 can be installed in a variety of ceiling environments.The use of the TBCR (Tile Bridge Support Ring) accessory may be desired for many of these environments. For suspended ceilings, the use of a TBCR is strongly recommended tohelp support and distribute the weight of the speak...
Speaker Wiring All wiring should be done prior to installationand then plugged into the rear of the OCS 1 . Wiring is terminated at a snap-lock input connector. There are two positive and twonegative terminals to accommodate daisy-chaining of speakers in a system. Daisy-Chaining The OCS 1 ’s snap-lo...
