Blodgett SC-10DS - Manual
Blodgett SC-10DS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – IMPORTANT NOTES FOR INSTALLATION AND OPERATION; Intended for commercial use only. Not for household use.
- Page 4 – SERVICE CONNECTIONS
- Page 5 – INSTALLATION INSTRUCTIONS; Set the unit in place and level using a spirit level.
- Page 6 – INFORMATION TO STEAM FITTER; Available
- Page 8 – OPERATING INSTRUCTIONS; Turn on the water and steam supply to the appliance.; OPERATION; be cooked into compartment and shut door.; SHUT DOWN; Turn off external steam supply valve.
- Page 9 – PERIODIC MAINTENANCE; Never spray water into electric controls.; CLEANING; Keep exposed cleanable areas of unit clean at all times.; ADJUSTMENTS
1
SC-6DS,SC-10DS and SC-16DS
DIRECT STEAM CONVECTION STEAMER
INSTALLATION – OPERATION
–
MAINTENANCE
BLODGETT OVEN COMPANY
www.blodgett.com
44 Lakeside Avenue, Burlington, Vermont 05401 USA Telephone (800) 331-5842, (802) 860-3700 Fax: (802) 864-0183
S00048 Rev B (12/04)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 IMPORTANT NOTES FOR INSTALLATION AND OPERATION It is recommended that this manual be read thoroughly and that all instructions befollowed carefully. This is the safety alert symbol. It is used to alert you topotential personal injury hazards. Obey all safety messagesthat follow this symbol to avoi...
4 1.0 SERVICE CONNECTIONS S ELECTRICAL CONNECTION: 1/2" conduit connection to controls. 120VAC-60Hz-1PH 2 AMPS per compartment or to be as specified on data plate. DRAIN: 2"IPS piped to open floor drain. No Solid Connection. COLD WATER: 3/8" O.D. tubing at 25-50 PSI(170-345 kPa). STEAM S...
5 2.0 INSTALLATION INSTRUCTIONS Ideally an exhaust system should be located directly above the appliance to exhauststeam and heat generated by the appliance. 1. Set the unit in place and level using a spirit level. 2. Ascertain that a floor drain (open gap) is convenient to the appliance drain. 3. M...
