Blaupunkt IVMR-1542- User Manual

18 CONTENTS Device overview ..................... 15 Ceiling-mounted monitor ................ 16IR remote control ........................... 17 Contents ................................. 18 Notes for the user .................. 19 Precautionary measures ................ 19 Safety notices .............

19 DANSK ENGLISH DEUTSCH FRANÇAIS IT ALIANO NEDERLANDS SVENSKA ESP AÑOL PORTUGUÊS Thank you for choosing a Blaupunktproduct. We hope you enjoy using thisnew piece of equipment. Please read these operatinginstructions before using theequipment for the first time. The Blaupunkt editors are constantlyw...

20 NOTES FOR THE USER NoteWe recommend that you allow aspecialist workshop to carry out theinstallation. Safety notices Please observe the following safetynotices during installation and whilstmaking the connections. - Disconnect the negative andpositive terminals of the battery. - When doing so, pl...

21 DANSK ENGLISH DEUTSCH FRANÇAIS IT ALIANO NEDERLANDS SVENSKA ESP AÑOL PORTUGUÊS INSTALLING THE MONITOR Screws for securing theceiling-mounted monitor Installing the monitor(mechanical) Select a suitable position for secure installation of the monitor: ● The device must not distract thedriver or re...

22 Cables INSTALLING THE MONITOR System cable(13 pin) Cable for theinterior lighting(3 pin) Adapter cable To avoid discharging the battery, werecommend you use a switchedoperating voltage (ignition). Warning notice: The operating voltagecable must be protected with at least a1.5 A fuse. Monitor conn...

23 DANSK ENGLISH DEUTSCH FRANÇAIS IT ALIANO NEDERLANDS SVENSKA ESP AÑOL PORTUGUÊS Controlling the interior lighting(monitor) There are two switches for the lights:ON 2 and interior lighting 4 . ON : This button is used to switch the lightson/off. Interior lighting : If activated, the lights only com...

24 OPERATION Switching on the monitor Press the power-on button 9 on the main unit or the button D on the remote control to switch the monitor on/off. Note:The button 9 lights up blue before the monitor is switched on. This means thatthe monitor is connected to the 12 Vvoltage supply. D H E F G I J ...

25 DANSK ENGLISH DEUTSCH FRANÇAIS IT ALIANO NEDERLANDS SVENSKA ESP AÑOL PORTUGUÊS OPERATION OSD menu Operation ➮ Press the MENU button : on the display or the MENU button I on the remote control to open theOSD menu. ● Use the arrow buttons 7 / 8 or I / to select the options. After you press the MENU...

26 Light bulb specifications Diameter: 8 mm Length: 28 mm Voltage: 12 V, 3 W Changing the battery in theremote control ➮ Push the button on the batterycompartment J to the right (see A below). ➮ Pull the battery compartment J out of the remote control (see Bbelow). ➮ Change the 3 V battery (CR 2025)...

27 DANSK ENGLISH DEUTSCH FRANÇAIS IT ALIANO NEDERLANDS SVENSKA ESP AÑOL PORTUGUÊS SPECIFICATIONS IVMR-1542 Screen size: 15,4" Monitor Screen resolution: 1280 (H) x 3 (RGB) x 800(V) Active area: 331,02 (H) x 207,0 (V) Signal system: Dual system NTSC/PAL Brightness: 220 cd/m 2 Contrast ratio: 400:...