Page 2 - The use and operation of navigation systems
The use and operation of navigation systems Attention! Don’t operate with the device while driving. Even the smallest and shortest distractions from road traffic for you and other road users - even at slow speeds - have devastating consequences. Type in the destination before starting your journey a...
Page 3 - A Navigation Software User
Moto Pilot 3.2 User’s Guide Table of Contents A Navigation Software User ‟ s Guide ............................................................................................................4 1 Main Window ................................................................................................
Page 5 - A Navigation Software User‘s Guide; Main Window
Moto Pilot 3.2 User’s Guide 5 A Navigation Software User‘s Guide IMPORTANT: When employing a navigation system in a vehicle, i.e., this software and the accompanying hardware, it is your responsibility to set up, secure and use the system in a manner that does not restrict your vision in any way and...
Page 7 - In the upper of the screen is current speed.
Moto Pilot 3.2 User’s Guide 7 1.1 Speed In the upper of the screen is current speed. In the upper right corner there is the speed limit on your road.
Page 11 - Volume
Moto Pilot 3.2 User’s Guide 11 1.3.2 Volume With this button you can adjust the volume of announcements. Click on the loudspeakers on the navigation screen to mute / silent. In Bottom right of the map an icon appears if the navigation is muted. Clicking on this icon activate the announcements again.
Page 12 - Route
Moto Pilot 3.2 User’s Guide 12 1.3.3 Route This feature allows you to enter to the route overview. This button is only active in the navigation otherwise it is gray and not clickable. Like in the destination view appears a vehicle icon on the left side of the map. A click on this button brings you b...
Page 13 - Zoom
Moto Pilot 3.2 User’s Guide 13 1.3.4 Zoom If this feature is enabled, you can drag a rectangle on the map, the map scale to temporarily change, for example for an increased oversight. If you draw a box around the target form the upper left to the lower right (green), the map viewer zooms in the sele...
Page 14 - Block Ahead
Moto Pilot 3.2 User’s Guide 14 1.3.7 Block Ahead The purpose of the Block KM function is to block the upcoming road section for a certain number of kilometers during active navigation. The navigation system will determine an alternative route bypassing the blocked section. This function is useful fo...
Page 15 - Favorites; You can open this dialog also with the star on the below.
Moto Pilot 3.2 User’s Guide 15 1.3.8 Favorites With the favorites you can directly navigate to the selected favorite. After selecting the favorite the navigation will start immediately from the actual position. You can open this dialog also with the star on the below.
Page 16 - Destination
Moto Pilot 3.2 User’s Guide 16 1.3.9 Destination This feature allows you to enter to the destination view. This button is only active in the navigation otherwise it is gray and not clickable. In the destination view appears a vehicle icon on the right side of the map. A click on this button brings y...
Page 17 - Arrow, Repeat last announcement
Moto Pilot 3.2 User’s Guide 17 1.4 While on Road 1.4.1 Arrow, Repeat last announcement While navigation you get the upcoming maneuver and distance on the lower left side.
Page 18 - Street name; The next street name and maneuver is displayed in the upper middle.
Moto Pilot 3.2 User’s Guide 18 1.4.2 Street name The next street name and maneuver is displayed in the upper middle.
Page 19 - Driving information; On the navigation bar, you can find the driving information.
Moto Pilot 3.2 User’s Guide 19 1.4.3 Driving information On the navigation bar, you can find the driving information. By clicking one of the driving information you can change your actual tour.
Page 21 - Lane information / Lane assistant
Moto Pilot 3.2 User’s Guide 21 1.4.5 Lane information / Lane assistant If there are lane information in the map data and your device supports this feature, you can see the lane information at the bottom in the middle. The tracks, which you can use are color coded.
Page 22 - On highways you can see the reality views.
Moto Pilot 3.2 User’s Guide 22 On highways you can see the reality views.
Page 23 - Enter destination
Moto Pilot 3.2 User’s Guide 23 2 Enter destination To enter a destination immediately, click the bottom right below the Menu button:
Page 27 - You do not need to enter „umlauts
Moto Pilot 3.2 User’s Guide 27 The previously entered letters are displayed in the top row of the screen. While you tap some letters may hidden on the keyboard. You do not need to enter „umlauts ‟ . In place of an „Ä ‟ simply enter „A ‟ , instead of „Ö ‟ enter „O ‟ , instead of „Ü ‟ enter „U ‟ . For...
Page 32 - You can add addresses, pois and coordinates.
Moto Pilot 3.2 User’s Guide 32 2.2 Favorites Favorites are frequently used addresses you can store in a list. This facilitates quick access to these destinations. When you start up the system for the first time, the favorites list is empty. You can add addresses, pois and coordinates.
Page 33 - You have the following options:
Moto Pilot 3.2 User’s Guide 33 By clicking on one of the arrows on the right you get the details of it: You have the following options: - Click on the name to start a route to the destination you chose - Use the "Map" button to display the destination on the map - Use the stylus to edit the ...
Page 34 - This can be addresses, pois and coordinates.
Moto Pilot 3.2 User’s Guide 34 2.3 Recent Under "Recent" you can find the latest targets approached. This can be addresses, pois and coordinates. You have the following options: - Click on the name to start a route to the destination you chose - Use the "Map" button to display the de...
Page 35 - With the tour function you can define Itineraries and save them.
Moto Pilot 3.2 User’s Guide 35 2.4 Tour With the tour function you can define Itineraries and save them. Depending on whether the navigation is active or not, some buttons are gray and not clickable.
Page 36 - New Tour; With this function you can create a new tour.
Moto Pilot 3.2 User’s Guide 36 2.4.1 New Tour With this function you can create a new tour. With the button „new destination“ you kann successively add different addresses, POIs or coordinates.
Page 38 - Here the “Mediapark” is marked as a via point.
Moto Pilot 3.2 User’s Guide 38 Here the “Mediapark” is marked as a via point. Via-points are destinations on which the route leads along, without informing the user about it. This is for example useful if you want to go from "location A" over "location B" to "location C" beca...
Page 39 - When you select a location you can switch the order or delete it.
Moto Pilot 3.2 User’s Guide 39 When you select a location you can switch the order or delete it. Click "GO" to start the route guidance to the first destination or via point. When you reach an intermediate destination, please confirming the route guidance to the next station. When you reach ...
Page 41 - With the „Simulation“ button you can simulate the Route in da Demo.; Load Tour / GPX tour; The GPX tour will be shown on load tour to use it.
Moto Pilot 3.2 User’s Guide 41 With the „Simulation“ button you can simulate the Route in da Demo. In this case, you need to define a start point to start the simulation. 2.4.2 Load Tour / GPX tour If you saved a tour before, you can use "Load Tour" to call and use it again. You can also loa...
Page 42 - Edit Tour; During navigation, you can edit and change the current tour.; Show Tour; During Navigation the current tour can be shown.
Moto Pilot 3.2 User’s Guide 42 You can also generate your own GPS Logs as GPX. After that you can load them as a Tour to use it in the navigation. 2.4.3 Edit Tour During navigation, you can edit and change the current tour. 2.4.4 Show Tour During Navigation the current tour can be shown.
Page 46 - Here you can see the category restaurants for example:
Moto Pilot 3.2 User’s Guide 46 Here you can see the category restaurants for example:
Page 49 - With the map function you can choose a destination via map:
Moto Pilot 3.2 User’s Guide 49 2.7 Map With the map function you can choose a destination via map: Like in the main window you have three several ways for choosing a destination: - Take position directly - Nearest Address Search - POI take on the marked position
Page 51 - After destination input you will see an overview over the route
Moto Pilot 3.2 User’s Guide 51 2.9 Route overview After destination input you will see an overview over the route Pleas commit the route on the Button in the below. If you want you can calculate an alternative route. Just click on the alternative button on the below. If no alternative was calculated...
Page 52 - Settings; In the settings you have all necessary menus for the navigation.
Moto Pilot 3.2 User’s Guide 52 3 Settings In the settings you have all necessary menus for the navigation. #
Page 53 - In this menu you find all settings regarding the map.; Map; The map can be used in 3 different views:; Autozoom
Moto Pilot 3.2 User’s Guide 53 3.1 Map In this menu you find all settings regarding the map. 3.1.1 Map The map can be used in 3 different views: - 3D direction (The camera angle behind the vehicle position icon and the map is turned in the direction of the vehicle icon) - 2D Northwards (map will rem...
Page 54 - The day/night view can be changed in addition to the quick menu here:; POI display
Moto Pilot 3.2 User’s Guide 54 3.1.4 Day/Night The day/night view can be changed in addition to the quick menu here: There is a day view, a night view which is not blinding so much at night and there is the function Geo-Daylight. In this day and the night view automatically switches to the actual su...
Page 55 - In this setting menu, all settings are made concerning the route:
Moto Pilot 3.2 User’s Guide 55 3.2 Routing In this setting menu, all settings are made concerning the route: 3.2.1 Route This setting determines by witch criteria the route will be calculated. The fastest route is mostly on the existing highways and is the default. The shortest route is the shortest...
Page 56 - Vehicle
Moto Pilot 3.2 User’s Guide 56 3.2.2 Vehicle Here you can select a vehicle profile. This has an impact on the routes and the calculated travel and arrival times. Depending on model and equipment you will find different options.
Page 57 - Low emission zone; Also ferries can be avoided, if you wish.
Moto Pilot 3.2 User’s Guide 57 3.2.3 Low emission zone You can also select your Emission class. This may have an effect on the route calculation. 3.2.4 Highways You can avoid highways, if you wish. 3.2.5 Toll roads You can avoid toll roads, if you wish. 3.2.6 Ferries Also ferries can be avoided, if ...
Page 59 - The alerts can be switched on or off as follows:
Moto Pilot 3.2 User’s Guide 59 The alerts can be switched on or off as follows: The speed camera detector can be independently turned on and off. His warnings are issued by a different tone and a display screen. Warnings for speed, red light speed cameras etc. issued. ATTENTION: Please note that not...
Page 62 - Brightness; Here you can select the brightness of the display.; Here you can change the volume.
Moto Pilot 3.2 User’s Guide 62 3.5 Hardware In the Hardware settings menu you can configure all hardware settings: 3.5.1 Brightness Here you can select the brightness of the display. 3.5.2 Volume Here you can change the volume.
Page 63 - Timezone; Here you can select your specific timezone:
Moto Pilot 3.2 User’s Guide 63 3.5.3 Timezone Here you can select your specific timezone:
Page 64 - GPS
Moto Pilot 3.2 User’s Guide 64 3.5.4 GPS Please note: The values for GPS are already set correctly for your system and should not be changed! Other settings may cause malfunction or failure of the system or parts of it! The GPS can be set either manually by clicking on the Com port and baud rate, or...
Page 65 - USB Mode; This will be necessary if you want to update your device.; Calibration
Moto Pilot 3.2 User’s Guide 65 3.5.5 USB Mode In this setting you can set the device in Active Sync or Mass Storage Mode. This will be necessary if you want to update your device. 3.5.6 Calibration In this setting you can calibrate the display. This may be necessary if the panel doesn’t react normal...
Page 66 - In this dialogue you can find the general settings:
Moto Pilot 3.2 User’s Guide 66 3.6 General In this dialogue you can find the general settings: The units setting is for setting the speed from km / h to mph. The time setting is used to switch from 12 - (AM / PM) on the 24-hour format. You can also switch the click sounds on and off. Use the "Re...
Page 69 - Pair; This function will make your device visible of other devices.
Moto Pilot 3.2 User’s Guide 69 3.1.1 Pair This function will make your device visible of other devices. Other devices can see and connect to MotoPilot.
Page 70 - Search
Moto Pilot 3.2 User’s Guide 70 3.1.2 Search With this function you can see other Bluetooth devices to connect with them.
Page 71 - Paired Device List
Moto Pilot 3.2 User’s Guide 71 3.1.3 Paired Device List Here you can see devices with was connected before to connect faster.
Page 72 - Settings; Configuration Wizard
Moto Pilot 3.2 User’s Guide 72 3.1.4 Settings In the settings you can set your device name, password and set the auto connect mode. 3.2 Configuration Wizard Here you can run the configuration wizard, which appears when you first start the navigation software again if necessary. He will guide you thr...
Page 73 - B Copyright Notice
Moto Pilot 3.2 User’s Guide 73 B Copyright Notice The product and the information contained in this document are subject to change without prior notification. This manual or any parts thereof may not be modified or duplicated without the express written permission of infoware GmbH. Data Source © <...
