Autostart AS-1785 - Manual

AS-1785 Installation Guide P. 5 Warning: at the Ignition Switch of certain vehicles, there may be more than one Ignition wire. Use the 5 th relay (Pin F) and extra relays to power up any extra Ignition wires if necessary. Do not jump wires at the Ignition Switch : this would compromise the OEM elect...

P. 6 Installation Guide AS-1785 Note: if the Tach signal is too low, the Remote Car Starter will “over-crank”. Conversely, if the Tach signal is too high, the Remote Car Starter will “under-crank”. 3 GREY (–) Hood Switch input Connect this wire to the installed Hood Pin switch supplied. This input w...

P. 10 Installation Guide AS-1785 12 YELLOW (+) Glow-Plug input (cont.) (Also known as the “wait-to-start light”.) The purpose of the Glow-plug circuit on diesel vehicles is to pre-heat the Combustion Chamber before the vehicle is started. When a Remote Starter is installed on a diesel vehicle, the G...

AS-1785 Installation Guide P. 11 12 YELLOW (+) Glow-Plug input (cont.) o Minimum waiting time is 3 seconds. o Maximum waiting time is 18 seconds. If no Glow-plug wire is found on the vehicle, the Glow-plug input on the Remote Car Starter may be “timed out”. The Remote Car Starter will power up the I...

Here are the steps which the installer must follow in order to flash the Hood Pin switch : The Installer … The Module … Press and hold the Hood Pin switch for 4 seconds. Release the Hood Pin switch. The Parking Lights will turn ON . While the Parking Lights are ON , press down the Hood Pin switch on...

AS-1785 Installation Guide P. 13 memory, you must perform a reset of the Remote Car Starter (see Resetting the Remote Car Starter , later in this Guide, for more details). The Transmitter Programming Procedure 1. Flash the Hood Pin switch (see Table 1) – The Parking Lights will stay ON for up to 20 ...

P. 14 Installation Guide AS-1785 Table 4: Accessing options In each Function, once an Option has been selected the Parking Lights will flash 1, 2, 3 or 4 times (depending on the selected Option). Please note that the different Functions within any particular Mode can only be accessed sequentially: t...

AS-1785 Installation Guide P. 15 FUNCTION 3 – Turbo Mode OPTION 1 Turbo Mode ENABLED OPTION 2* Turbo Mode DISABLED OPTION 3 Turbo Mode ENABLED FUNCTION 4 – Engine type and Cold Weather Mode OPTION 1 Diesel Mode with 20-minute Run Time in Cold Weather Mode OPTION 2* Gas Mode with 4-minute Run Time in...

P. 16 Installation Guide AS-1785 adjustment. Nevertheless, a Tach-programming procedure must be carried out every time a new Remote Car Starter Unit is installed . This is because the Tach signals of certain Ignition systems are sometimes too low or too high for the Remote Car Starter, causing faile...

AS-1785 Installation Guide P. 17 a. To increase the Horn pulse by 3 ms, press the LOCK button. b. To decrease the pulse by 3 ms, press the UNLOCK button. c. To increase the pulse by 10 ms, press the START or STOP button. d. To decrease the pulse by 10 ms, press the TRUNK button. 5. To save the new s...

P. 18 Installation Guide AS-1785 Remaining in ready Mode Once the vehicle is in Ready Mode, you can start and stop the vehicle at wish. However, should any one of the following occur, the vehicle will exit Ready Mode, thus disabling remote start capabilities until Ready Mode is restored: • Door open...

Most comebacks are the result of misunderstandings about how a product works or performs. Take the time to properly explain all functions and features to the customers before they leave the premises. Doing this will save time and money. Always make all your connections before plugging in the Remote ...

If the vehicle is initially unlocked , upon remote START the Remote Car Starter will start the Engine and arm the Starter Kill, but the Doors will not be locked or unlocked at any moment of the sequence. Lock Pulse Duration The duration of the Lock and Unlock pulses can be configured as follows: • (...

AS-1785 Installation Guide P. 23 2. Press and release the Break Pedal 6 times (within 10 seconds from entering Programming Mode). 3. The Parking Lights will flash 8 times to confirm resetting. Table 10: Resetting without a Valet Button On some vehicles (such as BMW and certain Volkswagen vehicles), ...

P. 24 Installation Guide AS-1785 Diagnostics – Parking Light Flash Table Flashes Description 1 • Doors locked, Starter Kill armed. • End of Run Time. • TRUNK button pressed • Start signal received by the Remote Car Starter. • Cold Weather Mode cancelled. • Cannot start after maximum number of attemp...