Audiovox WHS100 - Manual
Audiovox WHS100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Notes:
•
For best results, IR transmitter must be installed as
shown with the LED’s pointing toward the rear of the
vehicle (Fig. 1)
•
Audio input can be connected to either a low-level
fixed audio output or a variable level audio output
(such as a speaker or headphone output). If it is
connected to a low-level output, only the volume
control on the headphones needs to be adjusted to
control volume level. If connected to a variable level
output, volume adjustment needs to be done at both
the source and at the headphones.
Wire harness with RCA connectors (Fig. 2).
1. Using dual RCA (M/M) cable (not supplied, length
determined by installation) connect one end to red
and white RCA jacks. Connect the other end to low
level signal source.
2. Connect pin 4 (black wire, negative) to ground of
vehicle.
3. Connect pin 5 (red wire, +12 volt) to ignition source
(source that supplies +12 volts when the ignition is
switched on).
IR Transmitter
1. Plug wire harness into transmitter.
2. Remove lens on transmitter to expose screw holes
(Fig. 3).
3. Fasten transmitter to headliner using two short screws
(make sure that screws do not puncture metal of roof).
Wireless headphones
1. Follow directions in owner’s manual for proper
operation.
WHS100
Audiovox Wireless Infrared Headset
System Installation Instructions
Parts supplied
1. IR transmitter (1)
2. IR Transmitter harness (1)
3. IR headphones (2)
Fig. 1
TRANSMITTER
FRONT
REAR
POSITION JUST ABOVE THIGH AREA OF SECOND
PASSENGER ROW SEATING
Fig. 2
Fig. 3
TRANSMITTER POSITIONING DIAGRAM
TOP VIEW
SIDE VIEW
FACE LEDs TOWARDS REAR OF VEHICLE
WIRING DIAGRAM
IN-CAR TRANSMITTER
CEILING OF THE CAR
© 1998 Audiovox Corp., Hauppauge, N.Y. 11799
128-5372A
1. GROUND
2. WHITE
3. RED
4. BLACK
5. RED
4. DC 12V IN + (POSITIVE)
3. DC 12V GND – (NEGATIVE)
1. LEFT RCA CHANNEL IN
2. RIGHT RCA CHANNEL IN
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
