Audiovox RCR412SR - Manual

Battery Saver

Your universal remote control saves battery power by

automatically turning off if any key is pressed for more than

60 seconds. This saves your battery life should your remote

get stuck in a place where the keys remain depressed, such as

between sofa cushions.

Universal Remote Control
Owner’s Manual

RCR412BR / RCR412SR / RCR412SIR

Manual del Propietario (parte posterior)

SAVE THIS MANUAL AND THE CODE LISTS!
Remote controls can sometimes lose their programming

when you change the batteries. Make sure you keep the

manual and code lists in a safe place so that you can

reprogram the remote if you need to.

Tip: This remote is already programmed to operate

most RCA-branded TVs, VCRs, DVD players and satellite

receivers. Just press the corresponding key—DVD for

a DVD player, TV for a television, SAT•CBL•DTC for a

satellite receiver, VCR•AUX for a VCR.

Your universal remote requires two

AA

alkaline batteries

(batteries may or may not be included, depending on model).

To install the batteries:

1.

Remove the battery compartment

cover.

2.

Insert the batteries, matching the

batteries to the (+) and (–) marks

inside the battery compartment.

3.

Push the battery cover back into place.

Battery Precautions:

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc) or

rechargeable (nickel-cadmium) batteries.

• Always remove old, weak or worn-out batteries promptly

and recycle or dispose of them in accordance with Local

and National Regulations.

To use this universal remote with your home entertainment

system, first you need to program it to control your devices.

There are four ways you can program the universal remote to

operate your devices:

•

The

Auto Code Search

goes automatically through all the

codes for the device you’re trying to control. It’s the easiest

method, but it can sometimes take longer than some of the

other programming methods.

• The

Brand Code Search

searches through the codes for

select brands of devices. It’s not as easy as the auto code

search, but it can be faster.

• The

Direct Code Entry

lets you enter a code from the

accompanying code list for your brand of device. It’s not as

easy as the other methods, but it’s potentially the fastest

method.

• The

Manual Code Search

lets you manually go through

all the codes for the device you’re trying to control.

Auto Code Search

The Auto Code Search goes automatically through all the

codes for the device you’re trying to control. When you find

the one that operates your device, you can stop the search and

store that code.

1.

Manually turn on the device you

want to control.

2.

Press and hold the device key you want to program. While

you’re holding down the device key, use your other hand

to press and hold the remote’s

ON•OFF

key at the same

time.

3.

Wait until the

ON•OFF key

comes on and stays on. Then

release both keys.

4.

Point the remote directly at the

front panel of the device you

want to control. Press PLAY on

the remote and wait 5 seconds.

The remote is testing a batch of

10 codes on your device.

Did your device turn off?

YES:

Go to step

5

.

NO:

Press PLAY again. The remote tests the next batch of

10 codes.

Keep pressing PLAY every 5 seconds until your device

turns off.

Step 1: Install your batteries

Step 2: Program your remote

TIPS

: Each device key is associated with a type of device—

the TV is preset to search for TVs, SAT•CBL•DTC for satellite

receivers, cable boxes or digital TV converters, DVD for

DVD players, and VCR•AUX for VCRs or DVRs. To program

a device key for a different type of device, see the

Changing

a Key’s Device Type

section.

To exit without saving a new code at any point in the Auto

Code Search, press the

GO BACK

key.