Audiovox PRO-9649B - Manual
Audiovox PRO-9649B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – will not; ARMING THE SYSTEM - ACTIVE
- Page 5 – Programming Your Custom Override Code:; sequence. Turn the ignition switch to the on position.; Custom Code Programming Example:
- Page 6 – ELIMINATING THE NORMAL ARM/DISARM CHIRPS; seconds. The alarm will immediately sound.
- Page 7 – IGNITION CONTROLLED LOCK UNLOCK:
- Page 8 – SYSTEM FUNCTIONS AT A GLANCE; DASH LED INDICATORS
128-8190
1 of 8
Model: PRO-9649b
Owner’s Manual
3 Button Remote Security System
with Dual Stage Shock Sensor
IMPORTANT !
In order to provide the highest possible level of security to your vehicle, this
system is equipped with selectable manual override circuitry. It is possible that you will need
to manually override your security system if the transmitter becomes lost, or inoperative due to
battery failure. Reading the sections on
"MANUALLY OVERRIDING YOUR SYSTEM"
is nec-
essary to fully understand the procedure required to enable your vehicle in such situations.
In addition, the chart on the last page of this manual has a section for the particular features
and options installed in your vehicle as well as the override method selected.
Valet Switch
manual override is pre-selected from the factory,
however, the system can be config-
ured for "Custom Code" operation. Confirm the override mode selected on the last page of this
manual, and familiarize yourself with the selection on it's operation.
FEATURES:
2 Three Button Programmable RF Trans-
mitters
Five Channel Receiver
(capable of accepting 4 transmitters)
Code Hopping Technology
Selectable Manual Override Mode
Remote Panic in all modes
Protected Valet
User Programmable Manual Override
Code
7 Function LED - Arm / Disarm / Zone 1
/ Zone 2 / Zone 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone /
Tamper Confirmation
Instant Siren Activation
Starter Disable
True Last Door Arming (hardwire only)
Defective Zone By-Pass
Hardwire or Voltage Sense Selectable
Active or Passive Arming Selectable
Programmable Auto Lock On / Off
Programmable Auto Unlock On / Off
Programmable Door Lock Pulse Duration 1
Second/3.5 Seconds/1 Sec L/Dbl. U/L
Programmable Active or Passive Door
Locks
User Programmable Permanent Chirp Delete
On Command RF Chirp Delete from Trans-
mitter Or Selectable Through Software
6 Tone Multi Tone Siren (And or)
Car Horn Activation for additional alarm
response
Additional Negative Trigger Input
RF Inhibit with ignition on
Parking Light Flasher
R e m o t e T r u n k R e l e a s e ( m u s t h a v e
electronic trunk release)
Remote Keyless Entry With Optional
Access Guard (must have power door
locks)
Illuminated Entry
Plug In Dual Stage Shock Sensor
O P T I O N S :
Remote Trunk Release (must have electronic trunk release)
Remote Keyless Entry (must have power door locks)
Multiple Vehicle Capable
Remote Starter
Remote Power Window Roll Up
Remote Garage Door Interface
Headlight Illumination During Arming/Disarming, Or Both
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
128-8190 2 of 8 Page 2 YOUR "Code Hopping" TRANSMITTERS The transmitters included with your new security system use the most advanced andsecure form of radio frequency transmission available on any current automotive securitysystem. Some of today’s sophisticated auto thieves use a device kno...
128-8190 5 of 8 Page 5 door locks will remain operational. To use the valet mode, the system must first be disarmedeither by using your keychain transmitter, or by activating your personalized manual overridecode.1. Enter the vehicle, and turn the ignition key to the on position.2. Press and hold th...
128-8190 6 of 8 Page 6 4. Within 10 seconds turn the ignition switch off, on, off, on, off, on. (The siren or horn will beep and the lights will flash one time.) 5. Within 10 seconds, begin to press and release the PBLED switch to set the tenths digit. (As per the example, press and release 5 times ...
