Audiovox PA-S250 - Manual - manualsarea.com

Page 2 - INDEX

INDEX Specifications ................................................................................1Precautions ...................................................................................2Installation Instructions .................................................................3Wiring Ins...

Page 4 - PRECAUTIONS; The last lead to be connected is the wire to the positive (

PRECAUTIONS -2- 1. Although this unit is designed with built-in self-protection circuits, there may be a possibility of damage if it is not wired correctly. Please follow the wiring instructions carefully for the type of system being used. 2. The last lead to be connected is the wire to the positive...

Page 5 - CHECK BEFORE YOU

INSTALLATION INSTRUCTIONS INSTALLATION DIAGRAM 1. Select a mounting area where the amplifier will have sufficient air circulation for proper cooling.Inadequate air circulation will cause the temper-ature of the amplifier to rise and will trigger thethermal protection mode. 2. Place the amplifier on ...

Page 6 - WIRING INSTRUCTIONS; gauge or thicker (smaller gauge

-4- WIRING INSTRUCTIONS The wiring of your amplifier will depend on the system and speakers you are using but will either be a stereo, mono, ormixed-mono application. The following pages illustrate the input and output wiring for both types. Please refer to theappropriate diagrams for the system con...

Page 7 - Use either the low-level or the high-level inputs on the amplifier.

-5- 4. Speaker Connections Depending on the type and number of speakers used with the amplifier, wire them to the speaker terminals as perthe appropriate wiring diagram. For most applications, #18 gauge wire should be used for the speaker leads butin no case thinner than #20 gauge. For leads in exce...

Page 9 - STEREO AND MIXED-MONO OUTPUT WIRING DIAGRAM

EXISTING SCREW OR BOLTCLEANPAINT,RUST,DIRTORGREASE FROM AREA FORGOOD CONNECTION GROUNDEDMETALSECTION OF VEHICLE AUTO-ANTENNA LEAD -7- USE THIS OUTPUT WIRING WITH INPUT WIRING ON PAGE 6 STEREO AND MIXED-MONO OUTPUT WIRING DIAGRAM LEFT SPEAKER - 12 VOLT VEHICLE BATTERY CHASSIS GROUND USE #12 GAUGE WIR...

Page 10 - IMPORTANT

MONO (BRIDGED) INPUT WIRING DIAGRAM CAR STEREO LOW-LEVEL RCA OUTPUTS 4 3 2 5 "Y" RCA TYPE SHIELDED CABLE (NOT SUPPLIED) TO 2nd AMPLIFIER 1 IMPORTANT USE EITHER HIGH OR LOW-LEVEL INPUTS, NOT BOTH. HIGH-LEVEL (SPEAKER) OUTPUTS + - + - TO 2nd AMPLIFIER 4-PIN CONNECTOR -8- USE THIS INPUT WIRING ...

Page 12 - OPERATION; Power Indicator

-10- OPERATION After initial set-up, the amplifier should not require any further adjustment unless there is a change in the car stereoor speaker system with which it is used. 1 Power Indicator The Power LED functions as a power and warning indicator. The indicator is white when the power to theampl...

Page 14 - INTENTIONALLY LEFT BLANK

Page 15 - 2 / 24 MONTH LIMITED WARRANTY

AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof,under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, suchdefect(s) will be repaire...

Audiovox PA-S250 - Manual

Table of Contents:

Summary

Other Audiovox Models