Audiovox GMRS2VMK - Manual - manualsarea.com

Page 2 - CAUTIONS; Place the rubber cover on jacks when not in use.

CAUTIONS 2 Never attempt to charge alkaline or dry cell batteries, as batteries may burst causingpersonal injury and damage to the product. When recharging nickel metal hydride(NiMH) batteries with the Audiovox charger, use only Audiovox approved re-chargeable batteries. The Audiovox rechargeable ba...

Page 5 - GMRS2VMK DISPLAY; Beep Tone Indicator: Icon appears when beep button confirmation; HI LO

5 GMRS2VMK DISPLAY 1. Beep Tone Indicator: Icon appears when beep button confirmation tone is selected; icon disappears when tone is off. 2. Monitor Indicator: Icon appears when the Monitor (M) button is pressed and the channel monitor function is activated. 3. Key Lock Indicator: Icon appears when ...

Page 6 - Small Segment Display: Displays the CTCSS tone option in the; Powering the transceiver:; There are three methods of powering the GMRS2VMK:; WARNING: Do not attempt to recharge Alkaline batteries.; Audiovox Rechargeable NiMH Batteries -It is strongly recom-; NOTE: To extend battery life, avoid overcharging the batteries.

6 12.Caller Identification (ID) Indicator: This indication appears when you select a caller identification code (between 1 and 10). ID selectionoperates in conjunction with the small segment display, and can alsobe used to identify a calling party in the monitor mode. 13. Small Segment Display: Disp...

Page 7 - Installing the batteries:

7 2. S l i d e t h e c o v e r down and then liftcover at bottom too p e n . R e m o v ecover. 3. Insert four AAA batteries (positive (+) end towardthe bottom begining atleft side and alternatingp o s i t i v e t e r m i n a l s a sshown). 1. U s i n g t h u m b , press down onbattery cover atarrow ...

Page 8 - Mounting the Charger; Hold the charger up to the surface where is to be mounted.; VERTICAL MOUNTING

8 Mounting the Charger The Fast Intelligent Charger can be mounted horizontally or vertically ina vehicle. Mount the Fast Intelligent Charger using the following proce-dure: 1. Hold the charger up to the surface where is to be mounted. 2. Using a marker, mark the location of where the mounting holes...

Page 9 - Where to Install the Charger; MOUNT UNDER LIP OF TRUNK

Where to Install the Charger The Fast Intelligent Charger can be mounted horizontally or verticallyin any suitable location within the trunk, passenger compartment orrear cargo area of your vehicle. When mounting the charger in the trunkit maybe necessary route the cigarette lighter adapter wiring f...

Page 10 - Using the Fast Intelligent Charger; NOTE: Observe the charging LED indicators after one; CHARGING LED INDICATORS

10 Using the Fast Intelligent Charger The Fast Intelligent Charger will typically fully charge the transceiversin two hours. LEDs mounted on the front of the charger provide visualstatus of the charging process. Charging Indicators Status Steady Yellow: T h e c h a r g i n g p r o c e s s i s n o t ...

Page 11 - Powering the Charger with the Cigarette Lighter Adapter

Powering the Charger with the Cigarette Lighter Adapter The GMRS2VMK Fast Intelligent Charger obtains its operating power us-ing the Cigarette Lighter Adapter. Use the following procedure to connectthe charger to input power: 1. Insert the GMRS2VMK Cigarette Lighter Adapter connector intothe charger...

Page 12 - Mounting the Transceiver in the Charger; Press the transceiver firmly into the base.; Carry Clip Handle

Mounting the Transceiver in the Charger The transceiver is designed to lock into the Fast Intelligent Charger. Usethe following procedure: 1. While holding the transceiver in the palm of your hand, reach thecarry clip handle and press down to open the carry clip. 2. While the carry clip is in the op...

Page 13 - GMRS2VMK OPERATIONAL MODES; MODE; Press and hold the power on/off button (

GMRS2VMK OPERATIONAL MODES CALLSELECT MODE BUTTONBEEP ROGERBEEP DUALWATCH VOXSELECT I DSELECT CTCSSSELECT CHANNELSELECT Controls: Power On/Off (15) Button Press and hold the power on/off button ( ) for at least 2 seconds. You will hear a confirming melody to indicate the unit is on. To turn the unit...

Page 14 - Do not transmit if you hear conversation.

14 Monitor/Display Backlight Button (2)This button is used to check activity on the current frequency beforetransmitting. Check activity by pressing the Monitor (M) Button longerthan 2 seconds; the icon will apppear on the display and you will hear static if frequency is clear. Do not transmit if yo...

Page 15 - EMG appears on the display. Pressing this; ) icon will display in the top left corner.

15 Up Channel/Volume Button (10)In the standby mode, pressing this button will increment the listeningvolume. When in function edit mode this button will be used to adjust theunit’s settings.Down Channel/Volume Button (11)In the standby mode, pressing this button will decrement the listeningvolume. ...

Page 16 - Operating Modes and Features; seconds to turn on power.; - The CTC icon will be displayed on the LCD panel if the CTCSS tone; frequency function is enabled.; Channel Selection

16 Operating Modes and Features GMRS Operation: - From GMRS standby mode, press and hold the ( ) button for 2 seconds to turn on power. - Press the MODE button so the Channel number flashes.- Select the desired channel with the Up (10) and Down (11) Buttons. When receiving a call, the signal strengt...

Page 18 - Transmit Power Selection Mode; not change this setting unless it; VOX Selection Mode

18 Transmit Power Selection Mode This feature permits selection of the transmitting power level to highor low. (FRS channels 1-7 operate on low power.) Using low power,the unit will have a lower transmit range, but battery life will be in-c r e a s e d .NOTE: You will find that for the majority of y...

Page 19 - Dual Watch Mode; - To enable the dual watch mode, press the Up or Down button the dual; Roger Beep Tone; - From GMRS standby mode, press the MODE Button 6 times until rb

19 Dual Watch Mode This feature allows you to monitor two channels at the same time. While indual watch mode, the unit will continuously monitor both the primary anddual watch channel. Received signals will be played for 5 seconds, thenthe unit will resume scanning the two channels. Pressing the PTT...

Page 20 - Key Tone; identification code for your unit between 1 and 10.; Call Ringer Selection Mode

20 Key Tone This feature allows the transceiver to sound a confirmation tone wheneverthe following keys are pressed: Monitor (M) Button, Up/Down Buttons, MODEButton, SCAN Button, or the EMG Button.To turn the key tones on or off: - From GMRS/FRS standby mode, press the MODE Button 7 times until bP, ...

Page 22 - Emergency and Assistance Channel Mode; Out of Range Indication

- The Power, PTT, Up/Down, EMG and Monitor Buttons are not effected.- To unlock the Auto Key function, press and hold the SCAN button for at least 2 seconds; the icon ( ) disappears from the display. NOTE: If the unit is turned off while Key Lock is on, the Key Lockmode will still be in effect when ...

Page 23 - • Do not operate the transceiver unless you are licensed to do so.

NOTES FOR GOOD COMMUNICATION 1 . The GMRS2VMK 22 channels are shared on a ‘take turns’ basis. This means other groups may be talking on any of the channels.A c o m m o n c o d e o f ethics/courtesy is to switch to another vacantchannel and not to attempt to talk over someone who is already usingthe ...

Page 24 - Troubleshooting; P r o b l e m

Transceiver does Cigarette Ligther Adapter Check fuse and replace if not charge necessary. •Do not place your radio in front of a vehicle’s air-bag. If the air-bag de-ploys, it could propel the transceiver like a projectile causing bodily injury. Troubleshooting 24 Weak or no Weak batteries Charge o...

Page 26 - NOTE: Channels 1 through 7 are shared with FRS radios.; Main Channel Frequencies:

This transceiver complies with FCC regulations for use in the UnitedStates of America. Use in other countries may be prohibited or restrictedby local regulation. Please check with the local regulating agency be-fore using this device outside the United States of America. NOTE: Channels 1 through 7 a...

Page 27 - Continuous Tone Coded Squelch System Tone; CTCSS; oF

Continuous Tone Coded Squelch System Tone Frequencies (in Hz) CTCSS Freq. Hz CTCSS Freq. Hz 1 67.0 20 131.8 2 71.9 21 136.5 3 74.4 22 141.3 4 77.0 23 146.2 5 79.7 24 151.4 6 82.5 25 156.7 7 85.4 26 162.2 8 88.5 27 167.9 9 91.5 28 173.8 10 94.8 29 179.9 11 97.4 30 186.2 12 100.0 31 192.8 13 103.5 32 ...

Page 28 - 0 DAY LIMITED WARRANTY

28 90 DAY LIMITED WARRANTY AUDIOVOX CORPORATION, 150 MARCUS BLVD., HAUPPAUGE, NEW YORK 11788 1-800-290-6650 128-5385A Applies to Audiovox Family Radio and General Mobile Service Products. AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of thisproduct that should this pro...

Audiovox GMRS2VMK - Manual

Table of Contents:

Summary

Other Audiovox Models