Page 2 - Table of Contents
2 2010 Audiovox Electronics Corporation. All rights reserved. Before You Begin ...................................................................................... 3 Wire Connection Guide ........................................................................... 4 7 Pin Main Harness ................
Page 3 - PROFESSIONAL INSTALLATION; Installation Precautions:; Technical Support; or go to; BEFORE YOU BEGIN
3 2010 Audiovox Electronics Corporation. All rights reserved. PROFESSIONAL INSTALLATION STRONGLY RECOMMENDED Installation Precautions: Roll down window to avoid locking keys in vehicleduring installation Avoid mounting components or routing wires nearhot surfaces Avoid mounting components or routing...
Page 4 - Pin Start Harness
4 2010 Audiovox Electronics Corporation. All rights reserved. 6 Pin Start Harness 4 Pin Alternate Harness 2 Pin Lock Harness 7 Pin Main Harness 3 Pin Parking Light Harness
Page 5 - Pin Main Harness; Locate the vehicle’s dome light or pin switch wire.
5 2010 Audiovox Electronics Corporation. All rights reserved. 7 Pin Main Harness 1 BLACK/WHITE ILLUMINATED ENTRY OUTPUT ( - ) This wire provides a ( - ) 500mA output for 30 seconds when the system isdisarmed capable of driving relays. Locate the vehicle’s dome light or pin switch wire. Verification:...
Page 6 - TACH INPUT; GM VATS
6 2010 Audiovox Electronics Corporation. All rights reserved. 5 PURPLE/WHITE TACH INPUT Locate the vehicle’s ignition coil or fuel injector in the engine compartment. Verification: Test using the following procedure: 1. Set voltmeter to AC VOLTS.2. Attach positive lead of a volt meter to a constant ...
Page 7 - Pin Parking Light Harness
7 2010 Audiovox Electronics Corporation. All rights reserved. 6 GRAY HOOD PIN INPUT ( - ) Install a Hood Pin Switch and connect to the GRAY wire. This connection isrequired for Remote Start. Verification: This wire when connected will register ground when thevehicle's hood is opened. Connect the GRA...
Page 8 - NOTE: Remove all fuses until all connections are made.
8 2010 Audiovox Electronics Corporation. All rights reserved. 6 Pin Start Harness 1 PURPLE STARTER OUTPUT ( + ) Locate the vehicle starter wire. Verification: This wire registers voltage only when the key is turned to theSTART position. Verification:The starter wire registers voltage when the key is...
Page 9 - Pin Alternate Harness
9 2010 Audiovox Electronics Corporation. All rights reserved. 6 PINK IGNITION 1 ( + ) Locate the vehicle’s ignition wire at the ignition switch. Verification: This wire registers voltage when the key is turned to the ON (orRUN) position. The voltage does not drop out when the key is turned to theSTA...
Page 10 - Pin Lock Harness; BLUE
1 0 2010 Audiovox Electronics Corporation. All rights reserved. 4 BLACK/YELLOW PULSE DURING CRANK ( - ) Locate the vehicle’s second starter (crank) wire at the ignition switch. (if equipped) Verification: This wire registers voltage only in the start (crank) position ofthe ignition switch. Connect t...
Page 11 - Negative Switching Locks; Connect the GREEN and BLUE wires shown in the diagram below.
1 1 2010 Audiovox Electronics Corporation. All rights reserved. Negative Switching Locks All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock /unlock switch. Verification: These wires will register ground when the Lock and Unlockswitches are activated. Connect the GREEN and ...
Page 12 - Reverse Polarity Locks:; Negative Multiplexed Locks
1 2 2010 Audiovox Electronics Corporation. All rights reserved. Reverse Polarity Locks (5-Wire Door locks) All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock /unlock switch. Verification: These wires will rest at ground and register positivevoltage when the Lock and Unlock...
Page 13 - Positive Multiplexed Locks; Adding Aftermarket Actuators
1 3 2010 Audiovox Electronics Corporation. All rights reserved. Positive Multiplexed Locks All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock /unlock switch. Verification: This wire will show variable positive voltage when the switch isactivated. Please consult the wire an...
Page 14 - Data Bus Interface Port; Additional Ports; Tracking Port
1 4 2010 Audiovox Electronics Corporation. All rights reserved. Data Bus Interface Port This 4 pin port is used for Flashlogic Door Lock and Transponder DatabusInterfaces to communicate with the vehicle's Databus. When using the DBI port tocontrol the Flashlogic Door Lock and Transponder Interface m...
Page 15 - Manual Feature Programming - Feature Bank 2 - 4; Transmitter Programming - Feature Bank 1; Turn the ignition ON.
1 5 2010 Audiovox Electronics Corporation. All rights reserved. Manual Feature Programming - Feature Bank 2 - 4 1. Turn the ignition ON. 2. Press and hold the valet/override button. 3. Within 10 seconds the system will chirp (3) three times. 4. Use the valet/override button to advance through each o...
Page 16 - Refer to transmitter programming.
1 6 2010 Audiovox Electronics Corporation. All rights reserved. Feature Bank 1 - 3 Chirps Transmitter Programming Refer to transmitter programming.
Page 17 - Tach Programming; Turn the ignition key to the ON position.; Smart Tachless Mode; Within the 7 flash time period, press and hold the
1 7 2010 Audiovox Electronics Corporation. All rights reserved. Tach Programming The unit will not operate unless a tach signal is programmed or thetachless option is turned ON. If an attempt is made to start the vehicle via theremote start without first programming tach, the unit will flash the par...
Page 18 - Feature Bank 2 - Security; Feature Descriptions; Feature Bank 3 - Output Control; Second - Single 1 second lock pulse, single 1 second unlock pulse.
1 8 2010 Audiovox Electronics Corporation. All rights reserved. Feature Bank 2 - Security 1 - Silent Choice: Controls the normal arm/disarm chirps of the security system. ON - Silent arming/disarming upon first press of lock/unlock, pressing lock/unlock a second time will activate the arm/disarm chi...
Page 19 - Feature Bank 4 - Remote Start Control
1 9 2010 Audiovox Electronics Corporation. All rights reserved. 3 - Ignition Controlled Locks: Control of door locks when the ignition is cycledON or OFF. OFF - Door locks not activated by ignition. Lock and Unlock - Doors lock when ignition is turned on and unlock whenignition is turned off. Lock O...
Page 20 - - Crank Time: Preset output times for the PURPLE starter wire.; Second
2 0 2010 Audiovox Electronics Corporation. All rights reserved. 4 - Tach Mode: Determines how the system monitors the engine running duringremote start. Tach - Hard wired directly to the tach wire of the vehicle to monitor ACvoltage. Tachless (Crank Average/Voltage) - Determines crank time by averag...
Page 21 - Ignition 2 - Ignition output during remote start.; Transmitter Button Functions
2 1 2010 Audiovox Electronics Corporation. All rights reserved. 9 - Single / Double Pulse Start: Switches the remote start activation betweena single or double press from the transmitter. 10 - IGN 2 Output: Programmable high current output. Ignition 2 - Ignition output during remote start. Accessory...
Page 22 - Remote Start Shutdown Diagnostics; LED FLASHES
2 2 2010 Audiovox Electronics Corporation. All rights reserved. Remote Start Shutdown Diagnostics If the remote start shuts down or fails to start, the parking lights will flash one ofthe patterns below indicating the shutdown input. To manually enter diagnostics and view the last shutdown, turn the...
Page 24 - Audiovox Electronics Corporation.; FCC COMPLIANCE; This device may not cause harmful interference, and
2 4 2010 Audiovox Electronics Corporation. All rights reserved. Audiovox Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two condit...
