Audiovox AVX01BT3CL3 - Manual
Audiovox AVX01BT3CL3 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – The programming information described below assumes that the
- Page 3 – (b) Press and release the valet/override switch 1 time then move onto
- Page 6 – To help us expedite your order, please print all of the; ( New York state residents must include the appropriate sales tax. ); Mastercard; * Make checks payable to Audiovox Corporation
128-6105
1 of 6
1
Model AVX01BT3CL3
Released 7-25-01.
TRANSMITTER PROGRAMMING GUIDE
The transmitters included with the system have been pre-programmed at
the factory, with each button pre-assigned to control a specific function of
the system. Although the system in the vehicle has either a 3, 4, or 5 channel
RECEIVER, depending on the model, the transmitters included with the
system are 7 channel transmitters. This allows you to program each
transmitter to more than one vehicle in two car families and also allows you
to change which button or buttons control certain functions of the system.
(Example: Transmitter channel 5, shown below, can be programmed to
activate Receiver channel 2.) Refer to the chart below for access to each of
the transmitter channels, and for the standard factory button assignments.
TRANSMITTER
SYSTEM RECEIVER
CHANNEL BUTTONS CHANNEL
FUNCTION
1
1
Remote Arm
* Remote Emergency Panic
**Remote Door Lock
2
2
Remote Disarm
*Remote Emergency Panic
***Remote Unlock Drivers Door
**Remote Unlock All Doors
3
3
Push And Hold For 3 Seconds For Opt1
Release, Push 2 Times For Aux. Out.
4
4
**** Pulsed Output for Accessories
5
5
**** Switched Output for Accessories
6
-
**** RF
7
-
**** RF
&
&
&
&
&
* Remote Emergency Panic is available only on certain models.
** Door Lock/Unlock may require additional components in certain vehicles.
*** Unlock Driver Door or Unlock All Doors May Require Additional Components
**** Some of the more common accessories for these additional channels are;
AS 9075
Remote Car Starter
AS 9256
Remote Trunk Release Relay
AS 9154
Remote Garage Door Interface
AS 9153
Remote Window Roll Up
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
128-6105 2 of 6 2 PROGRAMMING TRANSMITTERS: It is important to remember that during programming, each individual step ofthe procedure must be executed within 15 seconds of the previous step.When the 15 second time limit is allowed to expire, the system willautomatically exit program mode. This is in...
128-6105 3 of 6 3 The chirp tone confirms that programming of channel 1 was successful.Up to 4 transmitters can be programmed, press and hold the selectedbutton of each additional transmitter until the chirp tone is heard, ormove to step #5 (b) You can assign the Lock/Unlock, Arm/Disarm button, by p...
128-6105 6 of 6 6 IMPORTANT: To help us expedite your order, please print all of the information legibly, and mail this form and your payment according to theinstructions below. Please indicate which button pad is used with yourtransmitter as indicated above.Transmitter model number is found on rear...
