Audiovox APS-45 - Manual
Audiovox APS-45 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – BEFORE BEGINNING THE INSTALLATION:
- Page 3 – Purple
- Page 5 – TRANSMITTER PROGRAMMING:; Engage/Disengage Panic Mode
- Page 7 – under the dash board or in the engine compartment areas.
Model APS-45
Installation Manual
Keyless Entry System
With Two Auxiliary Outputs
Installation Instructions
This Unit Is Intended For Installation In Vehicles With
12 Volt Negative Ground Electrical Systems Only.
Kit Contents:
w
APS-45 Control Module
w
(2) - Two Button Transmitters
w
4 Channel Code Learning Receiver
w
On Board Antenna
w
(1) - Multi Pin Input/Output Harness
w
(1) - Three Pin Door Lock Harness
w
(1) - Two Pin LED Indicator
w
(1) - Two Pin Valet / Override Switch
w
(1) - 10 Amp In-line Fuse Holder With Fuse
w
(1) - 5 Amp In-line Fuse Holder With Fuse
w
(1) - Installation Manual
w
(1) - Operator's Manual
w
(1) - Limited Warranty
w
(2) - Window Decals
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The APS-45 Keyless Entry System is designed to provide a convenient electronic means to gain access to the vehicle byproviding RF remote control over the vehicle's power door lock system. The unit also includes outputs to control thevehicle's dome lights, as well as exterior parking lights. Although...
3 light systems in these vehicles, you must use a separate SPDT relays to connect to each side in order to keep themisolated.Attach the WHITE wire of the system to this point. BROWN Wire: Negative (-) Door Sense Input WireIf the vehicle's interior lights are controlled by grounding door pinswitches ...
5 wire that provides a low current positive signal from the factory door lock switch to the factory door lock control relay. 3 Wire Positive Switched 2 Step Door LocksThe green wire provides a positive pulse during locking, or the pulsed + 12 volt lock output. Connect the green wire to thewire that ...
