Audiovox 5BLCR - Manual
Audiovox 5BLCR – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – REPLACING THE BATTERY:; Slide back the battery case cover in the direction shown.
- Page 5 – prevent accidential opening.
- Page 6 – Transmitter Ordering Department; ORDER FORM FOR TRANSMITTER
- Page 7 – THIS PAGE LEFT BLANK INTENTIONALLY
128-6690
1 of 8
Model 5BLCR &
5BLCRA
Programming Guide
The 5BLCR is designed to work with most Audiovox two way remote start unit
and may be programmed differently for other models. For the APS-55TW, the
recommended transceiver programming is shown below.
Note: A total of 4 transmitters may be programmed into any receiver channel.
1
Lock
2
Unlock
3
Remote Start/Stop
4
Option
The 5BLCRA is designed to work with most Audiovox two way alarm sys-
tems and may be programmed differently for other models. For the APS-590,
the recommended transceiver programming is shown below.
1
Lock
2
Unlock
3
Trunk Release (Optional)
4
Option
The intent of the Option button is to facilitate operation of other Audiovox RF
devices such as a second vehicle or a Garage Door Interface unit.
In the case of the APS-590, there is also an additional output on the control
module in the vehicle which may be programmed to operate from the Opt.
Button. Please check with your installation center for the programming of your
unit.
A total of 4 transmitters may be programmed into any receiver channel.
Force programming a transmitter, removing a transmitter, or reprioritizing a
transmitter is covered later in this manual.
Also, if you do not program a transmitter button into channel 2 which is the
separate unlock/disarm channel, then whatever button is programmed into
channel 1 will serve as both lock/arm & unlock/disarm.
Note: The “F” Button serves as a function button in combination with other
buttons explained in your owners manual. This button may not be used to
operate a receiver channel.
Note: Alarm units have a sounding device, siren or horn, keyless entry units
may or may not include a sounding device. Where mentioned, you may or may
not hear a chirp from the siren or horn. In the case of a keyless entry unit,
when entering a code, the unit will flash the parking lights to indicate the code
is learned.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
128-6690 4 of 8 2 Enter the transmitter program mode. Using any transmitter button pressand hold until a long chirp is heard. If a single chirp or multiple chirps, (up to7 chirps), are heard, the unit is indicating that the transmitter has alreadybeen programmed elsewhere in the receiver. Release th...
128-6690 5 of 8 3. Remove the discharged battery, making note of the location of the + and - contacts shown, and replace with a new type alkaline 1.5 volt AAA Battery. 4. Making note of the location of the (+) and (-) contacts, insert a new AAA battery alkaline 1.5 volt. 5. Replace battery cover bei...
128-6690 6 of 8 Attention: Transmitter Ordering DepartmentImportant: To help us expedite your order, please print all of the informationlegibly and mail this form and your payment according to the instructionsbelow. Specify 5BLCR ______ or 5BLCRA ______ 1) Name:______________________________________...
