Audiovox 50-0311x-015 Series - Manual
Audiovox 50-0311x-015 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MATERIALS PROVIDED FOR INSTALLATION:; ITEM Description; MOUNTING BRACKET
- Page 3 – I. PREPARATION OF VEHICLE INTERIOR; Disconnect wiring and lay light in a safe place.; FIGURE 1
- Page 4 – Install console mounting bracket (item 6 pg 2); II. INSTALLATION OF CONSOLE; Using a scribe or similar tool, align hole in rear of; FIGURE 6
- Page 5 – FIGURE 7
INSTALLATION INSTRUCTIONS
FOR
50-0311x-015 SERIES 1181337
GRAND CARAVAN
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions.
Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver
2. Powered screwdriver or drill with adapter
3. Awl or similar tool
4. Razor knife or similar
5. 18 GA wire 4' - 6'
6. Test light
7. Audiovox Series 640/650 Video Module
NOT FOR VEHICLES EQUIPPED WITH SUN ROOF.
Nov. 8, 1999
Printed in the U.S.A
INSTALLATION INSTRUCTION # 44-0047A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY 1 SCREW, # 8 X 9/16" PWH 4 2 SCREW, 6-32 X 3/4" PPH 6 3 WASHER, 3.5 mm 4 4 SCREW, # 8 X 1 1/2" PWH 1 5 SCREW, # 6 X 1/2" PFH 2 6 MOUNTING BRACKET 1 7 CONSOLE 1 8 SPEAKER GRILLE 1 9 COVER PLATE 1 10 COVER PLATE DECAL 1 INSTAL...
3 I. PREPARATION OF VEHICLE INTERIOR 1. Remove and retain (3) three screws which secure dome light in place. See Figure 1. 2. Disconnect wiring and lay light in a safe place. 3. Using O.E. console as a reference, carefully measure and trim headliner as shown. Caution: Before cutting headliner materi...
4 8. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video sys...
