Audiovox 50-0246x-015 Series - Manual
Audiovox 50-0246x-015 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MATERIALS PROVIDED FOR INSTALLATION:; ITEM Description; MOUNTING BRACKET; I. PREPARATION OF VEHICLE INTERIOR
- Page 3 – FIGURE 3
- Page 4 – FIGURE 4
- Page 5 – Note: Do not overtighten; FIGURE 6
- Page 6 – FIGURE 9
INSTALLATION INSTRUCTIONS
FOR
50-0246x-015 SERIES 1181270
1999 DODGE DURANGO *
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions.
Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver
2. Powered screwdriver or drill with adapter
3. Razor knife or similar
4. 1/4" hex socket bit
5. Awl or similar tool
6. 5/16" hex socket bit
7. Audiovox Series 640/650 Video Module
*
FOR USE IN VEHICLES EQUIPPED WITH FACTORY INSTALLED
REAR AIR CONDITIONING and WITH FACTORY OVERHEAD CONSOLE ONLY.
May 19, 1999
Printed in the U.S.A
INSTALLATION INSTRUCTION # 44-0024B
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY 1 SCREW, # 8 X 3/4 HWH 2 2 SCREW, # 8 X 11/4 PPH 1 3 SCREW, #10 X 3/4 HWH 2 4 SCREW, 6-32 X 3/4 PPH 6 5 WASHER, 3.5 mm 4 6 MOUNTING BRACKET 1 7 CONSOLE 1 I. PREPARATION OF VEHICLE INTERIOR INSTALLATION INSTRUCTION # 44-0024B May 19, 1999 Pr...
3 1. Remove and discard front mounting screw from overhead console and pull downward to release clips at rear of console. See Figure 1. 2. Disconnect wiring harness from console. See Fig. 2. Lay console in a safe place. Remove and retain (2) two O.E.M. screws from plastic bracket. Transfer Velcro ta...
4 4. Install mounting bracket (item 6 pg 2) and secure using (2) two # 10 x 3/4" screws (item 1 pg 2) in bottom flange that aligns with dimples in roof brace. Secure top flanges using (2) two # 8 x 3/4" screws (item 3 pg 2). See Figure 4. III. INSTALLATION OF CONSOLE NOTE: Additional assista...
