Audiovox 50-0244x-001 SERIES - Manual
Audiovox 50-0244x-001 SERIES – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MATERIALS PROVIDED FOR INSTALLATION:; ITEM Description; MOUNTING BRACKET
- Page 3 – Secure front of bracket to roof brace; FIGURE 1
- Page 4 – II. PREPARATION OF CONSOLE FOR INSTALLATION; Turn console upside down and remove and; FIGURE 4
- Page 5 – FIGURE
- Page 6 – Carefully insert modified console into vinyl; not overtighten screws.
- Page 7 – Install and route all video and audio cables, and
INSTALLATION INSTRUCTIONS
FOR
50-0244x-001 SERIES 1181275
50-0244x-018 SERIES 1181276
50-0244x-019 SERIES 1181277
CHEVROLET S-10 BLAZER
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions.
Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. T-15 TORX bit driver 4. Razor knife or similar
5. Awl or similar tool
6. 1/4” hex socket bit
7. Band saw or similar
8. Audiovox Series 640/650 Video Module
June 3, 1999
Printed in the U.S.A
INSTALLATION INSTRUCTION # 44-0025C
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY 1 SCREW, # 8 X 3/4" HWH 6 1 2 SCREW, # 8 X 3/4" PWH 4 3 SCREW, 6-32 x 3/4" PPH 4 2 4 WASHER, # 6 4 3 5 MOUNTING BRACKET 1 4 6 CONSOLE 1 7 FELT TAPE 3/4" X 8" 2 8 JUMPER HARNESS 1 INSTALLATION INSTRUCTION # 44-0025C June ...
3 I. PREPARATION OF VEHICLE INTERIOR 1. Remove the O.E.M. console mounted to inner roof of vehicle. Remove and discard dome light cover to gain access to (2) two #8 x 3/4" screws. Retain screws. Remove and retain (1) one #8 x 1 1/2" screw located in front of console near rear view mirror. Se...
4 II. PREPARATION OF CONSOLE FOR INSTALLATION 4. Turn console upside down and remove and retain (15) fifteen T-15 TORX screws which secure the cloth covered trim ring to console. See Figure 4. 5. Turn console over and open both compartment doors. Carefully separate the console from trim ring. Remove...
