Audiovox 1187001PL - Manual
Audiovox 1187001PL – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MATERIALS PROVIDED FOR INSTALLATION:; ITEM Description; MOUNTING BRACKET
- Page 3 – I. PREPARATION OF VEHICLE INTERIOR; Remove and retain rear A/C controls by pulling; FIGURE 1; is critical, do not overcut; FIGURE 2
- Page 4 – FIGURE 4; Install and route all video and audio cables, and any; FIGURE 5
- Page 5 – FIGURE 7
- Page 6 – II. INSTALLATION OF CONSOLE; FIGURE 9; Insert video system into opening in console.; Note: Make sure wires do not get pinched between video; Raise video screen into locked position.
INSTALLATION INSTRUCTIONS
FOR
55-0401x-121 SERIES 1187001PL
2001 DURANGO
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions.
Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver
2. Powered screwdriver or drill with adapter
3. Awl or similar tool
4. Digital Volt Meter
5. 18 GA wire 9'
6. Rubbing Alcohol
7. 5/16” Hex Socket Bit
8. Razor knife or similar
9. Pencil or equivalent
10. Measuring tape
11. Masking tape
12. Audiovox Video Module
NOT FOR VEHICLES EQUIPPED WITH SUN ROOF.
128-6067
Feb. 13,2001
Printed in the U.S.A
INSTALLATION INSTRUCTION # 44-0091A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY 1 SCREW, #8 X 9/16" PWH 2 2 SCREW, # 10 X 1/2" HWH,TEK 2 3 SCREW, 6-32 X 3/4" ,PPH 6 4 WASHER, 3.5 mm 4 5 MOUNTING BRACKET 1 6 CONSOLE 1 7 TEMPLATE 1 2 Feb. 13,2001 Printed in the U.S.A. INSTALLATION INSTRUCTION # 44-0091A
I. PREPARATION OF VEHICLE INTERIOR 1. Remove and retain rear A/C controls by pulling downward. Disconnect wire harness. See Figure 1. Set controls in a safe place for reuse later. FIGURE 1 2. Cut template (item 7 pg 2) in area #1. Locate and tape template to the headliner. Make sure template is cent...
FIGURE 4 4. Carefully pull (3) A/C wire harness clips from roof brace to extend length of wire harness. It may be necessary to lower the driver’s side of headliner at the “B” pillar to gain access to the 3 rd clip. See Fig. 4 Use caution when pulling on wire harness and pulling downward on headliner...
