Audiovox 1181293 - Manual
Audiovox 1181293 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MATERIALS PROVIDED FOR INSTALLATION:; ITEM; CONSOLE
- Page 3 – I. PREPARATION OF VEHICLE INTERIOR; Turn console over and place on a covered surface.; FIGURE 1
- Page 5 – FIGURE 5
- Page 6 – Secure bracket to sheetmetal frame using four; FIGURE 7
- Page 7 – If vehicle is equipped with an electronic; FIGURE 9
- Page 9 – Above headliner from video system to B-pillar.
- Page 12 – Do not overtighten screws.; Raise video screen into locked position.
INSTALLATION INSTRUCTIONS
FOR
50-0210F-002 SERIES 1181291
50-0210F-003 SERIES 1181292
50-0210F-004 SERIES 1181293
SUBURBAN
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions.
Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver
2. Powered screwdriver or drill with adapter
3. T-45 TORX bit driver
4. Razor knife or similar
5. Awl or similar tool
6. 1/4” hex socket bit
7. 7/64" drill bit
8. Small chisel
9. Audiovox Series 640/650 Video Module
FOR USE IN VEHICLES WITH FACTORY INSTALLED
OVERHEAD CONSOLE ONLY.
July 7, 1999
Printed in the U.S.A
INSTALLATION INSTRUCTION # 44-0019E
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY 1 SCREW, # 8 X 3/4" HWH ,TEK,Z1 4 2 SCREW, # 8 X 2 1/2" PFH ,ZII 3 3 SCREW, # 8 X 1 1/4" PWH ,BZ 4 4 CONSOLE 1 5 MOUNTING BRACKET 1 6 REAR LIGHT 1 7 REAR LIGHT TRIM 1 8 PLYWOOD, 3/8" X 6" X 14" 1 9 SCREW, # 6 X 1/2&#...
3 I. PREPARATION OF VEHICLE INTERIOR 1. Remove the O.E.M. compartment console currently mounted to inner roof of vehicle. Remove (1) one # 8 X 1 3/4" screw from recess in front of console near rear view mirror. Pull front of O.E.M. console down to access wiring. Disconnect all wiring from consol...
5 4. Remove OEM dome light and rear air conditioning control head. Disconnect wiring and set control head aside in a safe place. Remove the OEM ground screw near the center dome light assembly if applicable. See Figure 5. 5. Cut the headliner material between dome light opening and the front opening...
