Audiovox 1181279 - Manual
Audiovox 1181279 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Make sure the 27” cut is centered left to right in vehicle.; DO NOT OVERCUT HEADLINER.; Scribe a center line on the sheet metal roof of vehicle.; FIGURE 1
- Page 4 – II. PREPARATION OF CONSOLE FOR INSTALLATION; Carefully remove cover from respective switch; switches and controls are installed in the proper; Remove backing from tape on switch mounting; FIGURE 7
- Page 5 – FIGURE
- Page 6 – Note : Make sure wires do not get pinched; If speaker upgrade kit was not installed, install
INSTALLATION INSTRUCTIONS
FOR
50-0285x-015 SERIES 1181279
CHEVROLET VENTURE
OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read through
the following instructions.
Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. T-15 TORX bit driver 4. Razor knife or similar
5. Awl or similar tool
6. 1/4” hex socket bit
7. 18 GA wire 4'
8. Audiovox Series 640/650 Video Module
NOT FOR VEHICLES EQUIPPED WITH SUN ROOF.
MATERIALS PROVIDED FOR INSTALLATION:
June 2, 1999
Printed in the U.S.A
INSTALLATION INSTRUCTION # 44-0034A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 IF VEHICLE IS NOT EQUIPPED WITH FACTORY REAR A/C AND REAR AUDIO CONTROLS, PROCEED TO STEP 4. 1. Carefully remove the O.E.M. console mounted to inner roof of vehicle by pulling downward on sides to release clips. See Figure 1. 2. Lower console and disconnect wiring at (3) three locations. Remove an...
4 7. Remove and retain (2) two screws which secure front mounting bracket (item 6 pg. 2) to console (item 11 pg 2). Install front mounting bracket over O.E. brace, align slot with center line scribe and front edge of the O.E. brace. Make sure that the bracket is centered left to right. If applicable...
5 IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED. SEE FIGURE 9 FOR SUGGESTED LOCATIONS. III. INSTALLATION OF CONSOLE NOTE: Additional assistance in mounting the overhead console in vehicle is advised to prevent damage to console or components. Caution: Do not overtighten scr...
