AT&T D-10,000 - Manual

AT&T D-10,000

AT&T D-10,000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
Page: / 13

Table of Contents:

  • Page 2 – Contents; PRODUCTS
  • Page 4 – recommends the use of afterfilter(s) to remove final; Solenoid drain valves with isolation
  • Page 5 – dryers are industrial plate fin type coils, designed for maximum
  • Page 8 – g). Adjust solenoid drain valves for appropriate “open” time.
  • Page 9 – J. DESIGN CONDITIONS
  • Page 10 – Cooling Water Requirements; HEAT TO; TROUBLESHOOTING GUIDE
  • Page 11 – TROUBLESHOOTING GUIDE continued
  • Page 13 – AIR/TAK WARRANTY POLICY; AIR/TAK's line of quality compressed air system products includes:; For an authorized distributor near you, contact
Loading the manual


















107 W. Main Street

Worthington, PA 16262

Phone: 724.297.3416 Fax: 724.297.5189

http://www.airtak.com



OPERATING INSTRUCTIONS

Refrigerated Air Dryers Models D-320 through D-10,000





















4-2002






"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Contents; PRODUCTS

2 Contents A. INTRODUCTION B. RECEIVING C. LOCATION D. FOUNDATION E. PIPING F. ELECTRICAL G. COMPRESSED AIR CIRCUIT 1. Air to Air Heat Exchanger 2. Air to Refrigerant Heat Exchanger (Evaporator) 3. Drain Traps H. REFRIGERANT CIRCUIT 1. Refrigerant Compressor 2. Air-Cooled Condenser and Condenser Fan...

Page 4 - recommends the use of afterfilter(s) to remove final; Solenoid drain valves with isolation

4 In keeping with good compressed air piping design, the air dryer should be installed on the downstream side of the air receiver and aftercooler. An AIR/TAK prefilter(s) for oil and dirt removal installed at the inlet of the dryer is recommended. Contamination can be present in a compressed air sys...

Page 5 - dryers are industrial plate fin type coils, designed for maximum

5 G. COMPRESSED AIR CIRCUIT 1. Air-to-Air Heat Exchanger: This unique high-efficiency heat exchanger is of a finned shell and tube design. The tubes are of high quality copper and are enhanced by outer fins of corrugated aluminum. The air is first directed into the shell of the heat exchanger and is...

Other AT&T Models

All AT&T Other