Artusi ADW7002X User Manual - Free PDF Download

Page 5 - It provides better washing for

3 1. Worktop 2. Upper basket with racks 3. Upper spray arm 4. Lower basket 5. Lower spray arm 6. Filters 7. Rating plate 8. Control Panel 9. Detergent and rinse-aid dispenser 10. Cutlery basket 1 1 . Salt dispenser 1 2 . Upper basket track latch 1 3 1 2 3 5 6 7 8 9 10 11 12 4 Active Drying Unit: Thi...

Page 6 - Technical specifications; Important Note for User:

Capacity 1 5 place settings Height 8 0 mm Height (without worktop) 8 20 mm Width 59 8 mm Depth 598 mm Net Weight 46 kg Electricity input 220-240 V, 0 Hz Total Power 00 W Heating Power 8 00 W Pump Power 100 W Drain Pump Power 30 W Water supply pressure 0.03 MPa (0,3 bar) -1 MPa (10 bar) Current 10 A ...

Page 7 - SAFETY INFORMATION AND RECOMMENDATIONS; Recycling; When you take delivery of your machine

SAFETY INFORMATION AND RECOMMENDATIONS Recycling • Certain components and the packaging of your machine have been produced from recyclable materials. • Plastic parts are marked with international abbreviations: (>PE< , >PS< , >POM<, >PP<, ) • Cardboard parts have been produce...

Page 8 - In daily use

• Check whether the indoor electrical fuse system is connected according to the regulations. • All electrical connections must match the values indicated on the rating plate. • Pay special attention and be sure that the machine does not stand on the electricity supply cable. • Never use an extension...

Page 11 - Items not suitable for dishwashing:

Items not suitable for dishwashing: • Cigarette ashes, candle leftovers, polish, paint, chemical substances, iron-alloy materials; • Forks, spoons and knives with wooden or bone, or ivory or nacre-coated handles; glued items,items soiled with abrasive, acidic or base chemicals. • Plastic items that ...

Page 12 - Water connection; Be sure that the indoor plumbing is suitable for installing a

Position the machine close to a water tap or drain. You need to site your machine, taking into consideration that its connections will not be altered once they are made.Do not grip the machine by its door or panel in order to move it.Take care to leave a certain clearance from all sides of the machi...

Page 13 - Water inlet hose; old machine,if any. Use the new water inlet

Water inlet hose Do not use the water inlet hose of your old machine,if any. Use the new water inlet hose supplied with your machine instead. If you are going to connect a new or long - unused water inlet hose to your machine ,run water through it for a while before making the connection. Connect th...

Page 14 - Water outlet hose; or to the sink outlet spigot. Using a

Water outlet hose The water drain hose can be connected either directly to the water drain hole or to the sink outlet spigot. Using a special bent pipe (if available), the water can be drained directly into the sink via hooking the bent pipe over the edge of the sink. This connection should be at a ...

Page 15 - Electrical connection; Your machine is set according to 220-240 V. If the mains

Electrical connection The earthed plug of your machine should be connected to an earthed outlet supplied by suitable voltage and current. If there is no earthing installation, have a competent electrician carry out an earthing installation. In case of usage without earthing installed, our company wi...

Page 16 - Fitting the machine undercounter; worktop which are located at the rear of the machine then

Fitting the machine undercounter If you wish to fit your machine undercounter, check whether you have sufficient space under your countertop and whether the wiring-plumbing is suitable to do so. 1 If you decide that the space under the countertop is suitable for fitting your machine, remove the work...

Page 17 - IF

Adjust the machine feet according to the slope of the floor. 3 Fit your machine by pushing it undercounter without letting the hoses get crushed or bent. 4 Warning: After removal of worktop, the machine should be placed in such a closed place of which dimensions are shown at fig. 2 15 H Without In...

Page 38 - Warranty Card; ffi

Warranty Card Worldwide Appliances Pty Limited A.B.N. 45868077422O ffi ce: 48-50 Moore Street, Leichhardt N.S.W 2040 Post:Locked Bag 3000, Annandale, N.S.W 2038 P: 1300 694 583WARRANTY REGISTRATION Your ongoing satisfaction with your artusi product is important to us. We ask that you complete the en...

Page 39 - MODEL NUMBER; (a) These terms and conditions do not affect your; continued

4 Please complete and send to ARTUSI at: REPLY PAID 83617 LEICHHARDT NSW 2040 Last Name: First Name: Address: State: Postcode: Email: Home Phone: Mobile: Purchase Date: / / (Please attach proof of purchase to validate warranty) MODEL NUMBER SERIAL NUMBER (if you cannot locate the serial number pleas...