Ariens 921032 - Manual
Ariens 921032 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step One: Assemble Handlebars
- Page 6 – Connect Headlight Wire Harness
- Page 7 – Install Discharge Chute
- Page 8 – Discharge Chute Crank
- Page 10 – Install Skid Shoes
- Page 11 – Check Function of Dual Handle Interlock
- Page 12 – Check Tire Pressure
- Page 13 – Check Auger Gearcase Oil
- Page 14 – Check Engine Crankcase Oil
- Page 15 – Fill Engine Fuel Tank
- Page 16 – Step Thirteen: Starting the
- Page 17 – Choke
- Page 18 – Rocker Switch
- Page 19 – Fuel Shut Off Valve
- Page 20 – Key
- Page 21 – Prime
- Page 24 – Note
- Page 25 – Warm up
- Page 26 – Step Fourteen: Stopping the Engine
- Page 27 – Additional Resources; Refer to Owners Manual and Engine Manual
Quick Start Guide
Deluxe 30 (921032 s/n 101 & up)
•
Step 1: Assemble Handlebars
•
Step 2: Connect Headlight Wire Harness
•
Step 3: Install Discharge Chute
•
Step 4: Install Discharge Chute Crank
•
Step 5: Install Remote Deflector Control Cable
•
Step 6: Install Skid Shoes
•
Step 7: Check Function of Dual Handle Interlock
•
Step 8: Check Tire Pressure
•
Step 9: Check Auger Gearcase Oil
•
Step 10: Check Engine Crankcase Oil
•
Step 11: Fill Engine Fuel Tank
•
Step 12: Start Engine
•
Step 13: Stop Engine
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
IMPORTANT:
READ OPERATOR’S MANUAL AND ENGINE MANUAL
THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES
BEFORE OPERATING.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Step One: Assemble Handlebars (Unfold Lower Handlebar) IMPORTANT: Be sure to block wheels or secure unit so it does not move during assembly. 1. Rotate lower handlebar out from unit so lower handlebar mounting holes align with mounting holes on the unit frame. 2. Secure lower handlebar to unit using...
Step Two: Connect Headlight Wire Harness NOTE: The headlight wire harness comes attached to the upper handlebar assembly. 1. Route the wire harness along the interior of the right side handlebar. 2. Connect to the engine electrical plug. 3. Press cable anchor into mounting hole in the frame near the...
Step Three: Install Discharge Chute 1. Grease underside of discharge chute ring (if not already greased). 2. Remove mounting hardware from auger housing. 3. Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed above. NOTE: Leave discharge chute pede...