Ariens 921024 - Manual
Ariens 921024 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step One: Assemble Handlebars; NOTE: The Ariens company has made changes to
- Page 8 – Assemble Handlebar
- Page 9 – Install Discharge Chute
- Page 10 – Discharge Chute Crank
- Page 12 – Check Function of Dual Handle Interlock
- Page 13 – Check Tire Pressure
- Page 14 – Adjust Skid Shoes
- Page 15 – Check Auger Gearcase Oil
- Page 16 – Check Engine Crankcase Oil
- Page 17 – Fill Engine Fuel Tank
- Page 18 – Step Eleven: Starting the
- Page 19 – Choke
- Page 20 – Rocker Switch
- Page 21 – Fuel Shut Off Valve
- Page 22 – Key
- Page 23 – Prime
- Page 26 – Note
- Page 27 – Warm up
- Page 28 – Step Twelve: Stopping the Engine
- Page 29 – Additional Resources; Refer to Owners Manual and Engine Manual
Quick Start Guide
Deluxe 24 (921024 s/n 101 & up)
•
Step 1: Assemble Handlebars
•
Step 2: Install Discharge Chute
•
Step 3: Install Discharge Chute Crank
•
Step 4: Install Remote Deflector Control
•
Step 5: Check Function of Dual Handle Interlock
•
Step 6: Check Tire Pressure
•
Step 7: Adjust Skid Shoes
•
Step 8: Check Auger Gearcase Oil
•
Step 9: Check Engine Crankcase Oil
•
Step 10: Fill Engine Fuel Tank
•
Step 11: Start Engine
•
Step 12: Stop Engine
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
IMPORTANT:
READ OPERATOR’S MANUAL AND ENGINE MANUAL
THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES
BEFORE OPERATING.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Step One: Assemble Handlebars NOTE: The Ariens company has made changes to packaging that affects this serial number range. If the upper handlebars on your unit came already attached please disregard the following five slides. Not attached Attached
Step One: Assemble Handlebar 1. Remove the lower and loosen the upper hardware on the handlebar assembly. 2. Loosen the hardware on the shift rod. 3. Put the speed selector lever in the sixth forward position. 4. Rotate the handlebar into operating position. NOTE: Be careful not to damage cable spri...
Step Two: Install Discharge Chute 1. Grease underside of discharge chute ring (if not already greased). 2. Remove mounting hardware from auger housing. 3. Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed above. NOTE: Leave discharge chute pedest...
