Ariens 921023 - Manual
Ariens 921023 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step One: Assemble Handlebars; NOTE: The Ariens company has made changes to
- Page 9 – Assemble Handlebar
- Page 10 – Install Discharge Chute
- Page 11 – Discharge Chute Crank
- Page 13 – Check Function of Dual Handle Interlock
- Page 14 – Check Track Tension
- Page 15 – Adjust Skid Shoes
- Page 16 – Check Auger Gearcase Oil
- Page 17 – Check Engine Crankcase Oil
- Page 18 – Fill Engine Fuel Tank
- Page 19 – Step Eleven: Starting the Engine
- Page 20 – Throttle
- Page 21 – Fuel Valve
- Page 22 – Key
- Page 23 – Choke; Choke is
- Page 24 – Prime; Priming is
- Page 25 – If the engine
- Page 28 – Warm up
- Page 29 – Step Twelve: Stopping the Engine
- Page 30 – Additional Resources; Refer to Owners Manual and Engine Manual
Quick Start Guide
Deluxe-Track 28 (921023 s/n 75000 & up)
•
Step 1: Assemble Handlebars
•
Step 2: Install Discharge Chute
•
Step 3: Install Discharge Chute Crank
•
Step 4: Install Remote Deflector Control
•
Step 5: Check Function of Dual Handle Interlock
•
Step 6: Check Track Tension
•
Step 7: Adjust Skid Shoes
•
Step 8: Check Auger Gearcase Oil
•
Step 9: Check Engine Crankcase Oil
•
Step 10: Fill Engine Fuel Tank
•
Step 11: Start Engine
•
Step 12: Stop Engine
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
IMPORTANT:
READ OPERATOR’S MANUAL AND ENGINE MANUAL
THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES
BEFORE OPERATING.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Step One: Assemble Handlebars NOTE: The Ariens company has made changes to packaging that affects this serial number range. If the upper handlebars on your unit came already attached please disregard the following six slides. Not attached Attached
Step One: Assemble Handlebar 1. Remove the lower and loosen the upper hardware on the handlebar assembly. 2. Loosen the hardware on the shift rod. 3. Put the speed selector lever in the sixth forward position. 4. Rotate the handlebar into operating position. NOTE: Be careful not to damage cable spri...
Step Two: Install Discharge Chute 1. Grease underside of discharge chute ring (if not already greased). 2. Remove mounting hardware from auger housing. 3. Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed above. NOTE: Leave discharge chute pedest...
