Ariens 926039 - Manual
Ariens 926039 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION; Relieve Belt Tension; Install drive sheave and accessory sheave.
- Page 3 – Engine Mounting Hardware; Figure 4
- Page 4 – Remove Protective Cover From Recoil Housing; damage can occur if left in place.
Page 1 of 4
Date: Jul. 22, 2011 No. B-2078
Ariens Company has learned that some hardware used to mount the engine to the frame on the Pro
models listed below may have been omitted. This allows the potential for slight shifting of the engine and
possible belt misalignment. The plastic protective wrap applied to the recoil housing must also be removed
to prevent potential engine overheating.
:
A service kit (p/n 52610400) has been developed which includes hardware, engine mount bushings and a
washer for the engine sheave. Dealers are to order and install kit # 52610400 on all affected units.
Kit contents (Figure 1):
For each unit requiring service Dealers will be reimbursed 0.5 hours of labor at their standard shop labor
rates.
Ariens Company
655 W. Ryan St.
Brillion, WI 54110
www.ariens.com
Service Bulletin
Product Family: 2012 Pro-Series Sno-Thro
©
Models
Subject: Missing Engine Mounting Hardware, Remove Protective Covering from Recoil Housing
Dealer Action: Install Missing Hardware, Remove Protective Covering
Model
Description
Serial Number
926038
Pro 26
035001 – 035202, 035211 – 035224, 035234 – 035235
926039
Pro 32
035019, 035042 – 035065, 035077, 035090 – 035092
926040
Pro 36
035001 – 035003, 035007, 035024, 035040 – 035045
Item
No.
Part No.
Qty
Description
06543100
4
5/16-18 Locking Top Flange Nut
2
06435700
2
3/8 x 7/8 Flat Washer
3
05500937
2
.325 x .400 x .795 Bushing
(Silver Finish, Thin Wall)
4
05531500
2
.328 x .50 x .75 Bushing
Gold Finish, Thick Wall)
5
06443000
1
1 x 2 Flat Washer
Figure 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 of 4 Date: Jul. 22, 2011 No. B-2078 INSTALLATION Relieve Belt Tension (Figure 2) NOTE: Removing the drive and attachment belts releases tension on the engine to allow easier bushing installation. 1. Loosen hardware retaining belt cover and remove belt cover from unit. Retain cover. 2. Remove ...
Page 3 of 4 Date: Jul. 22, 2011 No. B-2078 Engine Mounting Hardware 1. Remove four hex nuts retaining engine to Sno-Thro frame. Note position of cable J-hook for reinstallation. Discard hex nuts but retain J-hook. 2. Install two silver thin-wall bushings (Item 3) over rear studs and slide down into ...
Page 4 of 4 Date: Jul. 22, 2011 No. B-2078 7. Install drive belt and accessory belts (Figure 6). 8. Install belt finger (B) and retain with hardware removed earlier (Figure 6). Torque to 132 lbf-in. 9. Ensure proper belt finger clearance: • With attachment clutch engaged belt finger on the side oppo...
