American Standard 2891 - Manual
American Standard 2891 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – RECOMMENDED; INSTALL WAX SEAL
- Page 3 – Push Button to test flush. If more stroke is; CARE AND CLEANING; tank. This damage can cause leakage and property damage.; Diagram 1; Rod Adjustment; Locknuts
- Page 4 – TROUBLESHOOTING GUIDE; PROBLEM; REPAIR PARTS LIST; DESCRIPTION; Replace TOP by engaging; For troubleshooting information please contact:; it is a signal you are wasting water because:
7 3 01 6 9 0 - 10 0 R e v. E
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2012
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Closet Bolts
Regular Screwdriver
Wax Ring/Gasket
Adjustable Wrench
Flexible Supply Tube
Sealant
Hacksaw
Carpenters Level
Tape Measure
ROUGHING-IN DIMENSIONS:
REMOVE OLD TOILET
1
2
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line.
NOTE:
If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE:
Mounting surface must be clean and level
before
new toilet is installed!
S
A
VE FOR FUTURE USE
BOULEVARD
®
Dual Flush One-Piece Toilet
Model 2891-Elongated Right Height
®
with Seat
Model 2891-BOULEVARD DUAL FLUSH ONE PIECE TOILET
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE:
Pictures may not exactly define contour of china and components.
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure
this product is installed properly, please read these instructions carefully before you begin. (Certain
installations may require professional help.) Also be sure your installation conforms to local codes.
!
INSTALLATION INSTRUCTIONS
Certified by
IAPMO R&T
NOTE:
Distance from wall to closet flange centerline must be as listed below:
IMPORTANT: Water supply on the wall is required at 3-3/4" or 9" from centerline of the toilet (see rough-in). First suggested position is
hidden behind the toilet. The geometry of the toilet gives space for this installation. The second suggested position is next to the toilet.
Between these two positions, the space for the supply between wall and toilet is limited to 3-1/4". In this case, check your supply and
hose dimensions.
29-3/4"
(756 mm)
7-1/2"
(192 mm)
3/4"
(1
9 mm)
18-1/2"
(470 mm)
16-1/2"
(419 mm)
14-1/2"
(368 mm)
30-7/8"
(784 mm)
13-1/2"
(345 mm)
14-1/4"
(364 mm)
8-1/2"
(217 mm)
12"
(305 mm)
C/L OF SEAT POST
HOLES 5-1/2"
(140mm) CENTERS
FINISHED WALL
3-3/8"
(86mm)
3-1/2"
(83mm)
SUPPLY
AS
REQUIRED
(position 1 or
position 2)
6"
(152mm)
5-1/2"
(140mm)
3-3/4"
(95mm)
9"
(229mm)
14"
(350 mm)
FINISHED
FLOOR
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
- 2 - 7 3 01 6 9 0 - 10 0 R e v. E 8a 8b Before continuing, determine the type of water supply connection you have from the chart below and use the appropriate assembly parts required to properly reconnect the water supply. DO NOT use plumber's putty to seal these fittings. CAUTION: DO NOT USE CONE ...
11 9 10 Turn on water supply. Submerge the FLOAT CUP under the water for 30 seconds. Adjust the water to desired level by turning WATER LEVEL ADJUSTMENT ROD and moving FLOAT CUP up or down. - 3 - 7 3 01 6 9 0 - 10 0 R e v. E FLUSH PUSH BUTTONS • The large flush button should line up over the white a...
7 3 01 6 9 0 - 10 0 R e v. E Does not flush Poor or sluggish flush Toilet leaks Toilet does not shut off a. Water supply valve closed. b. Supply line blocked. c. Sand or debris lodged in water control. a. Tank water too low. b. Bowl water too low. c. Water supply valve partly closed. d. Partially cl...
