American Standard ICU Sink System - Manual
American Standard ICU Sink System – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALL FAUCET
- Page 3 – Installation with ELECTRONIC BOX only is for cold; INSTALL ELECTRONICS HANGER BRACKET; COLD WATER; CONNECT SPOUT HOSE TO ENCLOSURE
- Page 4 – CONNECT WATER SUPPLY TO ENCLOSURE; NOTE: For complete detailed installation and; Note: If additional supply length is required, installer must; Installation Instr
- Page 5 – NOTE: If not enough tension, remove WIRE and spread; TO ENSURE A LAMINAR WATER FLOW
- Page 6 – INSTALL SINK APRON; OPTIONAL MOUNTING. (SCREWS AND ANCHORS NOT; IMPORTANT: SAVE ALL INSTALLATION INSTRUCTIONS FOR FUTURE USE
- Page 7 – Repair Parts; ICU Sink System; ICU Sink Shroud Kit
- Page 8 – AS AMERICA, INC. ONE YEAR LIMITED WARRANTY; In the United States:
7301793-100 Rev. D
1
Introduction:
Thank you for selecting our products...products which have been the
benchmarks of fine quality for years. To help insure that the installation process will
proceed smoothly, please read these instructions carefully before you begin. Also,
review the recommended tools and materials list; carefully unpack and examine your
new plumbing fixture.
Channel Lock Pliers
Regular Screwdriver
Recommended Tools & Materials
Rough-In
Dimensions
Phillips Screwdriver
Pipe Wrench
Drill
Plumbers' Putty or Caulking
Tubing Cutter
Tape
Measure
Hacksaw
Pencil
Torch
Level
S
A
VE FOR FUTURE USE
CAUTION: PRODUCT IS FRAGILE. TO AVOID DAMAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE:
Pictures may not exactly define contour of china and components.
ICU Sink System
Models: 9118.111, 9118.100 & 9118.150
INSTALLATION INSTRUCTIONS
!
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c .
© A S A m e r i c a , I n c . 2 0 1 2
14-3/4"
(375mm)
17"
(432mm)
4-3/4"
(121mm)
5/8"
(14mm)
1-5/8"
(41mm)
20"
(509mm)
4-3/4"
(120mm)
8" (203mm)
1/2" DIA.
(13mm)
FINISHED WALL
BASE MOUNT
DETAIL
FINISHED
FLOOR
FINISHED
FLOOR
FINISHED
FLOOR
26-1/8"
(663mm)
36"
(914mm)
36-1/2"
(927mm)
36-1/2"
(927mm)
40-1/8"
(1020mm)
2-3/4"
(70mm)
9/16" DIA.
(14mm)
2-3/4"
(70mm)
4"
(102mm)
4"
(102mm)
MOUNTING
STUDS
Adjustable Wrench
*
FAUCET PERCH
2-1/2" DIA. (65mm)
*
FAUCET PERCH
2-1/2" DIA. (65mm)
*DISCLAIMER: Faucets with a base diameter greater than 2-1/4" (57 mm) will not fit on this
ICU Sink. The Selectronic ICU Faucet was specifically designed to minimize splashing during
operation. American Standard will not be liable for any splashing that occurs if faucets other
than the American Standard ICU Faucets are used.
8"(203mm) BETWEEN
MOUNTING HOLES
RECOMMENDED CARRIERS:
JAY R. SMITH MFG. CO.
MODEL SQ-0-4437
FLOOR MOUNTED SINK SUPPORT
WATTS CA-311
FLOOR MOUNTED URINAL CARRIER
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 7301793-100 Rev. D NOTE: For ease of installation and accessibility, it is recommended that straight stops with flex supply tubes be used. As an alternative, if rigid supply risers are used, it is suggested to use angle stops in place of the straight stops. NOTE: For more detailed information, see...
7301793-100 Rev. D 3 4 5 6 INSTALL ICU SINK 1. Mount SINK onto the two HANGER STUDS. Hold SINK in place and temporarily install NYLOCK NUT & WASHER on one of the HANGER STUDS to retain SINK. MOUNT ELECTRONICS BOX COMPLETE WASTE OUTLET CONNECTION NOTE: Installation with ELECTRONIC BOX only is for...
4 7301793-100 Rev. D INSTALL AND CONNECT MIXING VALVE (MIXING VALVE IS OPTIONAL) CONNECT MIXING VALVE TO WATER SUPPLIES 11 10 12 ELECTRICAL HOOK-UP AND INSTALLATION COLD WATER OR TEMPERED WALL SUPPLY ELECTRONIC BOX 1 2 4 3 3 Installation Instr uctions (In Toronto Area only: 1-905-3061093) SELECTRONI...
