Page 2 - General safety
Contents Safety information 2 Safety information _ _ _ _ _ _ _ _ _ _ _ _ _2Product description _ _ _ _ _ _ _ _ _ _ _ _ 4Control Panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5Washing programmes _ _ _ _ _ _ _ _ _Helpful hints and tips _ _ _ _ _ _ _ __ _ _ 9First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10Personalisat...
Page 3 - ZANUSSI; Use
ZANUSSI 3 • All packing and transit bolts must be removed before use. Serious damage can occur to theproduct and to property if this is not adhered to.See relevant section in the user manual. • After having installed the appliance, check that it is not standing on the inlet and drain hose and thewor...
Page 4 - Product description; Quick Guide
Product description 4 1. Install the washing machine 2. Load the laundry 3. Measure out the detergent 4. Close the door 5. Install the drain and inlet hoses 6. Turn on the water tap 7. Plug the power supply 8. Select the desired programme 9. Press the [start/pause] button Quick Guide Accessories Inl...
Page 5 - Detergent dispenser drawer; Control panel; Programme selector dial; OPTIONS button
ZANUSSI ZANUSSI Compartment for detergent used for prewash and soak phase or for stain remover used during the stainaction phase (if available). The prewash and soakdetergent is added at the beginning of the washprogramme. The stain remover is added during thestain action phase. Compartment for powd...
Page 8 - Washing Programmes
8 !!!!! Energy test program: Cotton 60 intensiveStandard Wool program: 40 Compulsory Optional The parameter in this table are only for user ’s reference Washing Programmes 180M 1000M
Page 9 - Helpful hints and tips
Helpful hints and tips 9 ZANUSSI Sorting out the laundry Before loading the laundry Removing stains Blood: Oil based paint: Dried grease stains: Rust: Mould stains: Grass: Ball point pen and glue: Lipstick: Red wine: Follow the wash code symbols on each garment labeland the manufacturer’s washing in...
Page 10 - Degrees of water hardness; First Use; Additional buzzer selection
Degrees of water hardness Water hardness is classified in so-called«degrees» of hardness. Information on hardnessof the water in your area can be obtained fromthe relevant water supply company, or from yourlocal authority.When the degree of hardness is soft, re-adjustthe quantity of the detergent. 1...
Page 11 - Daily Use
Load the laundry Measure out the detergent and the fabric softener Select the required programme by means of theprogramme selector dial (1) Turn the selector dial to position to reset the programme or to switch the machine off. Important! Select the spin speed or the Rinse Hold option bypressing but...
Page 12 - Cancelling a programme; At the end of the programme
Cancelling a programme Turn the selector dial to to cancel a programme which is running, and wait few minutes to open thedoor (This is only possible if there is no water in thetub). By pressing any button the appliance will come out ofthe energy saving status. O O At the end of the programme Stand-B...
Page 13 - Care and cleaning; Descaling
Care and cleaning ZANUSSI 13 Warning! Descaling External cleaning Cleaning the dispenser drawer Cleaning the drawer recess You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. The water we use normally contains lime. It is a goodid...
Page 14 - Frost precaution or emergency emptied out
14 If you wash rugs, it is compulsory to inspect andclean the filter. Cleaning the water inlet filtersImportant! If the appliance doesn't fill, takes too long to fill withwater, the start button blinks yellow or the display (ifavailable) shows the relevant alarm (see chapter«What to do if...» for mo...
Page 15 - Malfunction
15 ZANUSSI What to do if..... Certain problems are due to lack of simplemaintenance or oversights, which can be solvedeasily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. Malfunction Possible Cause / Solution The washing machi...
Page 17 - Alarm codes; Reason
If the washing machine cannot work normally, a alarm code will appear on the display. Please carryout the following checks. Alarm codes ZANUSSI AlarmCode Status of Corresponding Indicators W ash Rinse Spin Off Off Flash Door lockproblem Door is not closed properly. Restart after the door is closed R...
Page 18 - Technical data
ZANUSSI If you are unable to identify or solve the problem,contact our service centre. Before telephoning, make a note of the product number, model, serial number and purchase date of your machine. The ServiceCentre will require this information. Technical data 60kg 2 00W 1 2 00W 1 60kg 520 520 5 7 ...
Page 19 - Installation; Unpacking
Installation Unpacking Positioning All transit bolts and packing must be removed beforeusing the appliance.You are advised to keep all transit devices so thatthey can be refitted if the machine ever has to betransported again. Unscrew the four bolts using a spanner.Slide out the relevantplastic spac...
Page 20 - Water drainage; Electrical connection; Packaging materials
ZANUSSI Caution! Water drainage Hooked over the edgeof a sink The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, youwill have to purchase a new, longer hose speciallydesigned for this type of use. The end of the drain hose can be positioned in threeways: u...
