Page 2 - Contents
Thank you for selecting ourappliance We wish you lots of enjoyment with your newappliance and we hope that you will considerour brand again when purchasing householdappliances.Please read this user manual carefully andkeep it throughout the product life cycle as areference document. The user manual ...
Page 3 - Safety information; Correct use
Safety information In the interest of your safety and to ensure thecorrect use, before installing and first using theappliance, read this user manual carefully, in-cluding its hints and warnings. To avoidunnecessary mistakes and accidents, it is im-portant to ensure that all people using theapplianc...
Page 4 - Installation; Control panel
Installation • Check your dishwasher for any transport damage. Never connect a damaged ma-chine. If your dishwasher is damaged con-tact your supplier. • All packaging must be removed before use.• Any electrical and plumbing work required to install this appliance must be carried out bya qualified an...
Page 5 - Setting mode
Setting mode The appliance is in setting mode when all programme lights are off and End of pro- gramme light flashes. IMPORTANT! Always remember that when performing opera-tions such as:• selecting a washing programme• setting the water softener• deactivation/activation of the audible signals the ap...
Page 6 - Audible signals; Programme selection/Cancel
Indicator lights End of programme indicator light Illuminates when the washing programme has ended.It also has added functions of visual signalling as:– the setting of the water softener,– deactivation/activation of the audible signals,– intervention of an alarm due to the malfunction of the machine...
Page 7 - Washing programmes
– End of programme light illuminates with fixed light, indicating that the audi-ble signals are active. 5. To deactivate the audible signals press again the Programme selection/Cancel button: the End of programme light turns off indicating that the audible signals havebeen deactivated. 6. To memoris...
Page 10 - Use of dishwasher salt
1. Press the On/Off button. The appliance must be in setting mode . 2. Press and hold Programme selection/ Cancel button until programme light A flashes and programme light B illuminates with fixed light. 3. After a few seconds: – programme light B turns off – programme light A goes on flashing – En...
Page 11 - Use of rinse aid
Remove any trace of salt. Replace the cap tightly turning it clockwise until itstops with a click. IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added. IMPORTANT! Top up the special salt when the light on thecontrol panel illuminates....
Page 12 - Adjusting the dosage of rinse aid; Load cutlery and dishes
Top up the rinse aid indica-tor ( B ) becomes clear CAUTION! Never fill the rinse aid dispenser with any other substances (e.g. dishwashercleaning agent, liquid detergent). This would damage the appliance. Adjusting the dosage of rinse aid Increase the dose if there are drops of water or limespots o...
Page 15 - Use of detergent; Detergent tablets; Unloading the dishwasher
Use of detergent IMPORTANT! Only use detergents suitable for dishwashers. Observe the manufacturer’s dosing and stor-age recommendations. Open the lid. Fill in the detergent incompartment A . Observe the dosing lev-els. For programmes with pre-wash add an additionaldetergent dose in com-partment B ....
Page 16 - Care and cleaning; Cleaning the filters; Cleaning the spray arms
• Water may appear on the sides and the door of the dishwasher as the stainless steel willeventually become cooler than the dishes. CAUTION! When the washing programme has finished, itis recommended that the dishwasher is un-plugged and the water tap turned off. Care and cleaning Cleaning the filter...
Page 17 - Frost precautions; Environment concerns; Packaging material
External cleaning Clean the external surfaces of the machine andcontrol panel with a damp soft cloth. Ifnecessary use only neutral detergents. Neveruse abrasive products, scouring pads or sol-vent (acetone, trichloroethylene etc....). Internal cleaning Ensure that the seals around the door, the de-t...
Page 18 - What to do if...
ponents are identified by markings, e.g. >PE<,>PS<, etc. Please dispose of the packagingmaterials in the appropriate container at thecommunity waste disposal facilities. CAUTION! When a unit is no longer being used: • Pull the plug out of the socket.• Cut off the cable and plug and dispo...
Page 20 - Technical data
The wash results are not satisfactory There are streaks, milky spots or a bluish coating onglasses and dishes • Decrease rinse aid dosing. Water drops have dries onto glasses and dishes • Increase rinse aid dosing.• The detergent may be the cause. Contact the de- tergent manufacturer’s consumer care...
Page 21 - Hints for test institutes
Consumption values Programme Programme duration (in minutes) Energy consumption (in kWh) Water (litres) Rinse and Hold 11 0,1 5 1) Test programme for Test Institutes Hints for test institutes Testing in accordance with EN 60704 must be carried out with appliance fully loaded and us-ing the test prog...
Page 22 - Water connection
cup racks: position A Lower basket Installation WARNING! Any electrical and/or plumbing work required toinstall this appliance should be carried out by aqualified electrician and/or plumber or compe-tent person. Water connection WARNING! The dishwasher must not be connected to openwater appliances o...
Page 23 - Drain hose
WARNING! The electrical cable for the safety valve is in thedouble-walled water inlet hose and is live.Therefore do not immerse the water inlet hoseor the safety valve in water.Take care when installing the water inlet hose. Place the water inlet hose in such a way thatit is always lower than the bo...
