Zanussi ZDT21002FA- User Manual

Page 3 - SAFETY INSTRUCTIONS

• Do not keep the appliance door open without supervision to prevent to fall on it. • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. • Do not use water spray and steam to clean the appliance. • The ventilation openings in the base (if applicable) mu...

Page 5 - EASY START; PROGRAMMES

EASY START 4 5 3 2 1 1 On/off button 2 Programme indicators 3 Indicators 4 Programme button 5 Half load button INDICATORS Running programme indicator. It comes on when the programme starts and goes off when the programme is completed. End indicator.Salt indicator. It is always off while the programm...

Page 6 - SETTINGS

Programme Degree of soil Type of load Programme phases Consumption values 1) Duration (min) Energy (kWh) Water (l) 4) Fresh soil Crockery and cutlery • Wash 60 °C or 65 °C • Rinses 30 0.8 9 5) All • Prewash 14 0.1 4 1) The pressure and the temperature of the water, the variations of the mains supply...

Page 8 - BEFORE FIRST USE

German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Water softener level 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 2 <4 <7 <0.7 < 5 1 2) 1) Factory setting 2) Do not use salt a...

Page 9 - DAILY USE

working. The washing phase starts only after this procedure is completed. The procedure will be repeated periodically. ADDING SALT Before first use put one litre of water in the salt container.Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, aft...

Page 11 - HINTS AND TIPS

END OF THE PROGRAMME • Press the on/off button to deactivate the appliance. • Close the water tap. If you do not press the on/off button, after few minutes from the end of the programme all the indicators go off. This helps to decrease the energy consumption. HINTS AND TIPS GENERALThe following hint...

Page 12 - CARE AND CLEANING

WHAT TO DO IF YOU WANT TO STOP USING MULTI-TABLETSBefore you start to use separately detergent, salt and rinse aid do the following procedure.1. Set the highest level of the water softener. 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing p...

Page 13 - TROUBLESHOOTING

C • Make sure that there are no residues of food or soil in or around the edge of the sump. • Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides. • Reassemble the filters (A) and (B). • Put back the filter (A) in the flat filter (C). Turn it clockwise...

Page 16 - TECHNICAL INFORMATION

Problem Possible cause and solution There are residues of detergent in the dispenser at the end of the programme. • The detergent tablet got stuck in the dispenser and therefore was not completely washed away by water. • Water cannot wash away the detergent from the dispenser. Make sure that the spr...

Page 17 - ENVIRONMENT CONCERNS

RATING PLATE Mod. ... ... ...Prod. No. ... ... ... Ser. No. ... INFORMATION FOR TEST INSTITUTESFor all the necessary information for test performance, send an email to:[email protected]Write down the product number (PNC) that is on the rating plate. ENVIRONMENT CONCERNS Recycle the materials with th...

Zanussi ZDT21002FA- User Manual

Table of Contents:

Summary

Other Zanussi Models