Zanussi IZ 12 - Manual

5 Description of the Appliance 1 Detergent dispenser drawer 2 Control panel 3 Door locked light 4 Door opening handle 5 Filter 6 Adjustable feet Door locked light It stays on during the whole programme indicating thatthe door is locked.When the light goes out, the door can be opened (seepage 12). De...

1 ON/OFF button Press this button to switch the washing machine on.The display (8) will show three blinking dashes or ablinking zero. You will find more detailed explanationson page 7 (see “DISPLAY”).Press the ON/OFF button again to switch the machineoff. 2 MAINS-ON light This light is connected to ...

8 Important! The first time you use the washing machine , when you switch it on, it may display a blinking zero and givean audible warning signal. This is due to the fact that thewashing machine has performed a washing cycle duringthe manufacturer’s inspection tests, and this cycle hasnot been erase...

10 Operating Sequence Before the first wash, we recommend that you run acotton cycle at 60°C, without any laundry in themachine, to remove any manufacturing residue from thedrum and tub.Pour 1/2 a measure of detergent into the dispenserdrawer and start the machine. 1.Load the laundry Open the door. ...

13 Washing Hints Do NOT overload the machine. Weigh the laundry the first few times you use the appliance. The average weights of the most common items arelisted below as a guide: 1000g = 1 kg Sheet 700-1000 g Pillow case 100-200 g Tablecloth 400-500 g Serviette 50-100 g Tea towel 70-120 g Linen han...

15 Wash Care Symbols Wash care labels inside garments recommend how to launder your clothes with the best results. The care labellingcode is in line with care labelling used in the rest of Europe. The symbols used make it easy to select the correctprogramme on your washing machine. WASHING SYMBOL BL...

16 Washing programmes The “coloured cotton programme” at 60°C is the reference programme for the data entered in the energy label, incompliance with EEC 92/75 standards. * This data is given purely as an indication: the consumption values may vary in relation to the quantity and type of laundry, the...

17 Maintenance and Cleaning Before any maintenance or cleaning is carried out youmust DISCONNECT the appliance from the electricity supply. Descaling The water we use normally contains lime. It is a goodidea to periodically use a water softening powder in themachine. Do this separately from any laun...

18 When no more water comes out, unscrew the filter andremove it. Clean the filter under a running tap, then refit it,screwing it fully in. Put the cap back on the emergency emptying hose,place the latter back in its seat. Close the filter door. Warning When the appliance is in use and depending on ...

19 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily withoutcalling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listedbelow.IMPORTANT: if you call out an engineer to a fault liste...

20 Symptom The door will not open Possible causes ● The water level is above the bottom edge of the door. ● The machine is heating the water. ● The drum is turning. The door can only be opened when the relevant light has gone out. Spinning starts late or the machinedoes not spin ● The electronic unb...

21 Zanussi Guarantee Conditions Standard guarantee conditions We, Zanussi undertake that if, within 12 months of thedate of the purchase, this Zanussi appliance or any partthereof is proved to be defective by reason only offaulty workmanship or materials, we will, at our option,repair or replace the...

25 Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all the packaging for re-use incase the machine is to be transported again. Using a spanner unscrew and remove the rear right bolt.Lay the machine gently on its back, making sure that theho...

26 If you cannot make the cold water connection directfrom the rising mains, you may be able to operate theappliance from your cold water storage system. There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom ofthe water storage tank. Set the hose correctl...

27 Levelling Level the washing machine by raising or lowering thefeet. The feet may be tight to adjust as they incorporatea self locking nut, but the machine MUST be level andstable (check diagonally). Any necessary adjustment can be made with a spanner.Accurate levelling prevents vibration, noise a...

28 Electrical connection Any electrical work required to install this applianceshould be carried out by a qualified electrician orcompetent person. WARNING: THIS APPLIANCE MUST BEEARTHED. The manufacturer declines any liability should this safety measure not be observed. Before switching on, make su...