Zanussi FA1032- User Manual

6 DIMENSIONS Height 85 cm Width 60 cm Depth 60 cm MAXIMUM LOAD Cotton 4,5 kg Synthetics 2 kg Delicates 2 kg Woollens 1 kg SPIN SPEED 1000 rpm max. POWER SUPPLY VOLTAGE/FREQUENCY 230 V/50 Hz TOTAL POWER ABSORBED 2100 W MINIMUM FUSE PROTECTION 10 A WATER PRESSURE Minimum 5 N/cm 2 Maximum 80 N/cm 2 Thi...

ENGLISH 7 Installation Transit security bars Before starting the machine up, the transportsecurity bars must be removed as follows:You are advised to keep all the transport securitybars in case the appliance has to be transportedagain. 1. Unscrew and remove the three rear screwsby means of a key. 2....

ENGLISH 9 This new machine meets all modern requirements for effective treatment of laundry with low water, energy anddetergent consumption. • The temperature selector dial will allow you to choose the most suitable temperature for your laundry. • The balance control device ensures the machine is st...

10 Use 1. Programme chart It will help you to choose the most suitable washingprogramme for your laundry. 2. Spin speed selector This dial has the following positions:• 0 = no spin for cotton • 300 = MIN, for cotton • 1000 = MAX, for cotton. For synthetics, delicates and wool the maximumposition cor...

ENGLISH 11 Washing hints Sorting the laundry Follow the wash code symbols on each garmentlabel and the manufacturer’s washing instructions.Sort the laundry as follows:whites, coloureds, synthetics, delicates, woollens. Temperatures 90° for normally soiled white cottons and linen(e.g. tea cloths, tow...

12 Ink: depending on the type of ink, moisten the fabricfirst with acetone (*), then with acetic acid; treat anyresidual marks on white fabrics with bleach and thenrinse thoroughly. Tar stains: first treat with stain remover, methylatedspirits or benzine, then rub with detergent paste. (*) do not us...

ENGLISH 13 International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Delicate wash Max. wash temperature 95°C Max. wash temperature 60°C Max. wash temperature 40°C Max. wash temperature 30°C Hand wash Do not ...

14 4. Select the temperature Turn the dial to the required setting. 5. Select the option push button/s and the spin speed. 6. Select the programme and start the machine Turn the programme selector dial clockwise to therequired programme.Before pulling the On/off programme selector check if: • The do...

ENGLISH 15 7. At the end of the programme The machine stops automatically. The mains on lightgoes out. If you have selected a programme which ends withthe water of the last rinse left in the tub, drain thewater before opening the door. Select programme“P” (drain) or “G” (spin). Wait one or two minut...

16 Programme table Washing programmes for cotton and linen Load: 4,5 kg In compliance with EC directive 92/75, the consumption figures indicated on the energy label refer to the 60°Cwash programme for cotton (programme “B”) with a wash load of 4.5 kg. ( * ) When this button is pressed, the last rins...

ENGLISH 17 Programme table ( * ) When this button is pressed, the last rinse water of these programmes is not emptied out, so as to avoidcreasing if the laundry is not removed from the machine immediately after washing. To drain the waterselect programme “G” (spin) or “P” (drain). Washing programmes...

18 1. Bodywork Clean the outside of the machine with warm waterand a neutral, non-abrasive household detergent.Rinse with clean water and dry with a soft cloth. Important: do not use methylated spirits, solvents orsimilar products to clean the bodywork. 2. Detergent dispenser drawer After a while, d...

ENGLISH 19 4. The water inlet hose filter If it takes longer to fill up the washing machine it istime to check the water inlet hose filter it may beclogged. Turn off the water tap. Unscrew the fixing nut of the inlet hose. Remove the filter from the electrovalve and clean itwith a hard bristle brush...

20 Something not working? Problems which you can resolve yourself. Problem Possible cause • The machine does not start up: • The door is not firmly closed. • The machine is not plugged in or there is no power at the socket. • The main fuse has blown. • The programme selector is not positioned correc...