Winegard 1000 - Manual
Winegard 1000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Raising the Antenna
- Page 3 – Removing the Reflector and LNB Assembly
- Page 4 – NOTE; NOTE; Installing the DISH Reflector and LNB Assembly
- Page 5 – TIP
- Page 6 – Setting the IDU for DISH 1000
- Page 7 – Re-packaging the Removed LNB for RP-SK21 Users; Re-packaging the Removed LNB for OE-DISH Users
Replacement DISH
®
1000
LNB Assembly
www.winegard.com/mobile
For Technical Services,
email [email protected] or call 1-800-788-4417
2452138
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Follow the steps below to raise the antenna for reflector, bracket, and LNB assembly removal. Pay attention to the pinch points as the antenna raises. See below. Press [POWER] , and hold for two seconds to turn on the TRAV’LER ® interface box. Wait until the interface box finishes “connecting to ant...
If converting a DIRECTV SWM Slimline antenna to a DISH TRAV’LER antenna, remove the power inserter and SWM splitter; these will not be used. Remove the four reflector nuts and bolts, and remove the dish. Set the nuts and bolts aside. Disconnect the coaxial cables from the turret. Note that the D por...
Remove the bolts holding the reflector bracket to the skew housing. NOTE If replacing a Slimline assembly with a DISH assembly , remove and set aside the stiffener plate inside the reflector bracket. Remove the LNB arm assembly, and set aside. NOTE If replacing a Slimline assembly with a DISH assemb...
