White Rodgers 5059 - Manual
White Rodgers 5059 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5398
Printed in U.S.A.
5059
Pilot Relight Control
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BE-
FORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PER-
SONAL INJURY AND/OR PROPERTY DAMAGE.
PART NO. 37-4778B
Replaces Part No. 37-4778A
9514
DESCRIPTION
Operator: Save these instructions for future use!
INSTALLATION INSTRUCTIONS
The 5059 Pilot Relight Control is a low voltage control that
generates ignition sparks. It is energized by the thermo-
stat on a call for heat. Once flame is established, the
control senses the flame and stops sparking. If the pilot
flame is extinguished during a call for heat, the relight
control will begin sparking immediately upon sensing
absence of flame. The control delivers very low current
sparks (approximately 6,000 volts).
PRECAUTIONS
WHITE-RODGERS
CAUTION
!
SPECIFICATIONS
Electrical Rating:
24 VAC (30 VAC max.)
60 Hz
0.030 Amps
Mounting:
Surface mount or 2” x 4” switch box
Ambient Temperature Range:
-40
°
F to +175
°
F
WARNING
!
CAUTION
!
If in doubt whether you wiring is millivolt, line, or low
voltage, have it inspected by a qualified heating and air
conditioning contractor, electrician, or someone familiar
with basic electricity and wiring.
Do not exceed the specification ratings.
All wiring must conform to local and national electrical
codes and ordinances.
This control is a precision instrument, and should be
handled carefully. Rough handling or distorting compo-
nents could cause the control to malfunction.
To prevent electrical shock and/or equipment
damage, disconnect electrical power to the sys-
tem, at the main fuse or circuit box, until installa-
tion is complete.
Label all wires prior to disconnection when ser-
vicing controls. Wiring errors can cause improper
and dangerous operation.
Following installation or replacement, follow
appliance manufacturer’s recommended instal-
lation/service instructions to insure proper op-
eration.
This control is not intended for use in locations
where it may come in direct contact with water.
Suitable protection must be provided to shield
the control from exposure to water (dripping,
spraying, rain, etc.).
Do not use on circuits exceeding specified volt-
age. Higher voltage will damage the control and
may cause shock or fire hazard.
WHITE-RODGERS DIV.
EMERSON ELECTRIC
C
A
U
T I
O N
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
