White Rodgers 1F86ST-0471 - Manual
White Rodgers 1F86ST-0471 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Remove Old Thermostat; Figure 2 – Thermostat base and rear view of thermostat; Figure 1 – Battery door shown open
- Page 3 – Home Screen Description; THERMOSTAT QUICK REFERENCE; Programming and Confi guration Items; WIRING CONNECTIONS; Terminal Designation Description; Compressor Relay
- Page 4 – INSTALLER/CONFIGURATION MENU
- Page 6 – OPERATING YOUR THERMOSTAT; Set Current Time and Day; Arrancar; to exit the Time mode.; Enter the Heating Program; PROGRAMMING (For Programmable Model Only)
- Page 7 – Keep the following guidelines in mind when planning your program.
- Page 8 – TROUBLESHOOTING; Reset Operation; Be sure to review the installer confi guration menu settings.; VENT; button simultaneously. The; Symptom
Description
Gas or Oil Heat
Yes
Electric Furnace
Yes
Heat Pump (No Aux. or Emergency Heat)
Yes
Heat Pump (with Aux. or Emergency Heat)
No
Systems with up to 3 Stages Heat, 2 Stages Cool
No
Heat Only Systems
Yes
Millivolt Heat Only Systems – Floor or Wall Furnaces
Yes
Cool Only Systems
Yes
Hydronic (Hot Water) Zone Heat – 2 Wires
Yes
Hydronic (Hot Water) Zone Heat – 3 Wires
Yes
www.white-rodgers.com
80 Series Thermostat with
Automatic Heat/Cool Changeover Option
PART NO. 37-6952A
0827
Single Stage or Heat Pump
Installation and Operating Instructions for Model:
APPLICATIONS
THERMOSTAT APPLICATION GUIDE
1F80ST-0471 Thermostat
with Spanish Display
SPECIFICATIONS
Electrical Rating:
Battery Power . . . . . . . . . . . . . . . . . . . . . . . . . . mV to 30 VAC, NEC Class II, 50/60 Hz or DC
Input-Hardwire . . . . . . . . . . . . . . . . . . . . . . . . . 20 to 30 VAC
Terminal Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.0 A per terminal, 1.5A maximum all terminals combined
Setpoint Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45° to 90°F (7° to 32°C)
Differential (Single Stage) . . . . . . . . . . . . . . . . . . . . Heat 0.6°F; Cool 1.2°F (adjustable)
Differential (Heat Pump) . . . . . . . . . . . . . . . . . . . . . Heat 1.2°F; Cool 1.2°F (adjustable)
Operating Ambient . . . . . . . . . . . . . . . . . . . . . . . . . . 32° to +105°F (0° to +41°C)
Operating Humidity . . . . . . . . . . . . . . . . . . . . . . . . . 90% non-condensing max.
Shipping Temperature Range . . . . . . . . . . . . . . . . . -40° to +150°F (-40° to +65°C)
Dimensions Thermostat . . . . . . . . . . . . . . . . . . . . . . 3.4"H x 4.4"W x 1.3"D
CAUTION
!
To prevent electrical shock and/or equipment damage,
disconnect electric power to system at main fuse or circuit
breaker box until installation is complete.
ATTENTION: MERCURY NOTICE
This product does not contain mercury. However, this
product may replace a product that contains mercury.
Mercury and products containing mercury must not be
discarded in household trash. Do not touch any spilled
mercury. Wearing non-absorbent gloves, clean up any
spilled mercury and place in a sealed container. For proper
disposal of a product containing mercury or a sealed
container of spilled mercury, place it in a suitable shipping
container. Refer to www.white-rodgers.com for location to
send product containing mercury.
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS
CAREFULLY BEFORE INSTALLING OR OPERATING THIS
CONTROL COULD CAUSE PERSONAL INJURY AND/OR
PROPERTY DAMAGE.
Model
Programming Choices
1F80ST-0471
5/2 Day
5/1/1 Day
Non-Programmable
1F86ST-0471
Non-Programmable
Save these instructions for future use!
Index
Page
Installation
2
Wiring Connections
3
Thermostat Quick Reference
3
Installer Confi guration Menu
4
Operating Your Thermostat
6
Programming
6
Troubleshooting 8
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 WARNING ! Thermostat installation and all components of the control system shall conform to Class II circuits per the NEC code. INSTALLATION Remove Old Thermostat A standard heat/cool thermostat consists of three basic parts: 1. The cover, which may be either a snap-on or hinge type. 2. The base, ...
3 Displays the power level of the2 “AA” batteries: indicates good power level. indicates batteries at abouthalf power. “ Cambiar ” (Change ) indicates batteries are low and should be replaced with 2 new premium brand “AA” Alkaline batteries. Time Day of Week Setting Temperature RoomTemperature Tempe...
4 INSTALLER/CONFIGURATION MENU Press the Menu button for at least 5 seconds. The display will show item #1 in the table below. Press Menu to advance to the next menu item. Press or to change a menu item. Shaded items are not available on 1F86. 1. Select Reversing Valve Output (SS/HP switch must be s...
