Whirlpool W10182361A - Manual

Page 2 - You; Your safety and the safety of others are very important.; DANGER

2 TABLE OF CONTENTS DRYER SAFETY.............................................................................. 2 INSTALLATION INSTRUCTIONS .................................................. 3 Tools and Parts ............................................................................ 3Options .........

Page 3 - INSTALLATION INSTRUCTIONS; Tools and Parts; Parts supplied; Parts needed; If using a power supply cord:; IMPORTANT SAFETY INSTRUCTIONS

3 INSTALLATION INSTRUCTIONS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Parts supplied Remove parts packages from dryer drum. Check that all parts are included. ■ Parts package 4 Leveling legs...

Page 4 - Height; WARNING; Explosion Hazard

4 Options Pedestal Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of different heights separately for this dryer. You may select a 10" (25.4 cm) or 15.5" (39.4 cm) pedestal. These pedestals will add to the total height of the dryer for a total height of ...

Page 5 - Installation spacing for custom undercounter installation; Custom undercounter installation - Dryer only

5 ■ A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. If slope is greater than 1" (2.5 cm), install Extended Dryer Feet Kit, Part Number 279810. Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level. ■ For a garage ins...

Page 6 - Mobile home - Additional installation requirements; Electrical Requirements; It is your responsibility

6 Recommended installation spacing for cabinet installation ■ For cabinet installation, with a door, minimum ventilation openings in the top of the cabinet are required. * Required spacing ** For side or bottom venting, 0" (0 cm) spacing is allowed. Recommended installation spacing for recessed ...

Page 7 - Electrical Connection; If your outlet looks like this:; GROUNDING INSTRUCTIONS

7 ■ To supply the required 3 or 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply (or 3 or 4 wire, 120/208 volt electrical supply, if specified on the serial/rating plate) on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recom...

Page 8 - Style 1: Power supply cord strain relief; Power Supply Cord

8 Electrical Connection 1. Disconnect power. 2. Remove the hold-down screw and terminal block cover. 3. Install strain relief. Style 1: Power supply cord strain relief ■ Remove the screws from a ³⁄₄ " (1.9 cm) UL listed strain relief (UL marking on strain relief). Put the tabs of the two clamp s...

Page 9 - Style 2: Direct wire strain relief; Electrical Connection Options; Go to Section

9 Style 2: Direct wire strain relief ■ Unscrew the removable conduit connector and any screws from a ³⁄₄ " (1.9 cm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal...

Page 12 - Optional 3-wire connection

12 When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block (hook facing right), squeeze hooked end together and tighten screw, as shown. 1. Loosen or remove center silver-colored terminal block screw. 2. Place the hooked end of the neutral wire (...

Page 13 - Venting Requirements; If using an existing vent system; Fire Hazard

13 Venting Requirements WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS. IMPORTANT: Observe all governing codes and ordinances. The dryer exhaust must not be connected into any gas vent, chimney, wall, ceiling or a concealed space of a building. If using an existing vent s...

Page 14 - Plan Vent System; Choose your exhaust installation type; Alternate installations for close clearances

14 ■ An exhaust hood should cap the vent to keep rodents and insects from entering the home. ■ Exhaust hood must be at least 12" (30.5 cm) from the ground or any object that may be in the path of the exhaust (such as flowers, rocks or bushes, snow line, etc.). ■ Do not use an exhaust hood with a...

Page 15 - Vent system chart; Install Vent System; Install exhaust hood. Use caulking compound to seal exterior; Connect vent to exhaust hood. Vent must fit inside exhaust; Install Leveling Legs; To protect the floor, use a large flat piece of cardboard from; Excessive Weight Hazard

15 ■ Over-the-Top Installation: Part Number 4396028 ■ Periscope Installation (For use with dryer vent to wall vent mismatch): Part Number 4396037 - 0" (0 cm) to 18" (45.72 cm) mismatch Part Number 4396011 - 18" (45.72 cm) to 29" (73.66 cm) mismatch Part Number 4396014 - 29" (73.6...

Page 17 - DRYER USE; Starting Your Dryer; Clean lint screen before each load. See “Cleaning the Lint

17 DRYER USE Starting Your Dryer WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. This manual covers several different models. Your dryer may not have all of the cycles and features described. The follo...

Page 18 - Stopping Your Dryer; To stop your dryer at any time; Pausing or Restarting; To pause the dryer at any time; To restart the dryer; Control Locked; Drying tips

18 ■ Press and hold START button until dryer starts (about 1 second). Once an Automatic cycle has started, the WRINKLE SHIELD™ feature and cycle signals can be adjusted. Press the PAUSE/CANCEL key twice to stop the dryer and clear the settings, allowing you to select another cycle and Dryness Level....

Page 19 - Status Lights; NOTE: The Damp light is not used with manual cycles.; Cycles

19 ■ Avoid drying heavy work clothes with lighter fabrics. This could cause overdrying of lighter fabrics, leading to increased shrinking or wrinkling. ■ If you dry sheets in a mixed load or large items in the Bulky Items cycle, rearrange the load when the signal sounds. This will aid in the drying ...

Page 20 - Additional Features; Temperature

20 Damp Dry Use this cycle to dry items to a damp level using Low heat. Damp dry items such as jeans (to avoid stiffness) or cotton clothing (to make ironing easier). The temperature setting on this cycle cannot be adjusted. Items will have different levels of dampness. At the end of this cycle, clo...

Page 21 - Changing Cycles, Options and Modifiers; Drying Rack Option

21 ■ Stop at any time by pressing the WRINKLE SHIELD™ feature or opening the dryer door. ■ For the Casual Cycle, the WRINKLE SHIELD™ feature is preset to “ON.” The other cycles will retain the WRINKLE SHIELD™ feature setting. (For example, if you select the WRINKLE SHIELD™ feature in the Normal cycl...

Page 22 - DRYER CARE; Cleaning the Dryer Location; Every load cleaning

22 To use the drying rack Do not remove the lint screen. 1. Open dryer door. 2. Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure over the lint screen. 3. Put the wet items on top of the drying ...

Page 23 - Cleaning the Dryer Interior; Electrical Shock Hazard

23 IMPORTANT: ■ Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. ■ If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See “Venting Requirements....

Page 24 - TROUBLESHOOTING; Dryer Operation; Dryer will not run; Is the dryer door firmly closed?; No heat

24 TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call... In U.S.A. www.whirlpool.com/help - In Canada www.whirlpool.ca Dryer Operation Dryer will not run ■ Has a household fuse blown...

Page 25 - Dryer Results; Cycle time too short; Was the load removed from dryer at the end of the cycle?; Odors

25 Dryer Results Clothes are not drying satisfactorily, drying times are too long, or load is too hot ■ Is the lint screen clogged with lint? Lint screen should be cleaned before each load. ■ Is the exhaust vent or outside exhaust hood clogged with lint, restricting air movement? Run the dryer for 5...

Page 26 - ASSISTANCE OR SERVICE; If you need replacement parts; Our consultants provide assistance with:; For further assistance; ACCESSORIES; Part Number

26 ASSISTANCE OR SERVICE Before calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance...

Page 27 - Notes

Page 28 - WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY; LIMITED WARRANTY; Any food loss due to refrigerator or freezer product failures.; DISCLAIMER OF IMPLIED WARRANTIES LIMITATION OF REMEDIES

WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter “Whirlpool”) will ...

Whirlpool W10182361A - Manual

Table of Contents:

Summary

Other Whirlpool Models