Whirlpool W10151595A - Manual

Page 2 - You; Your safety and the safety of others are very important.; DANGER

2 TABLE OF CONTENTS DRYER SAFETY.............................................................................. 2 INSTALLATION INSTRUCTIONS .................................................. 3 Tools and Parts ............................................................................ 3Location Requi...

Page 3 - INSTALLATION INSTRUCTIONS; Tools and Parts; Tools needed; Mobile home installations require; Location Requirements; You will need; IMPORTANT SAFETY INSTRUCTIONS; WARNING; Explosion Hazard

3 INSTALLATION INSTRUCTIONS Tools and Parts Tools needed Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Parts supplied Remove parts package from the dryer drum. Check that all parts listed are included. ■ 1 - Cy...

Page 4 - Recessed or closet installation - Dryer only; Mobile home installations require:

4 Do not operate your dryer at temperatures below 45ºF (7ºC). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirem...

Page 5 - Electrical Requirements; It is your responsibility; Electrical Connection; If using a power supply cord:; If your outlet looks like this:; GROUNDING INSTRUCTIONS

5 Electrical Requirements It is your responsibility ■ To contact a qualified electrical installer. ■ To be sure that the electrical connection is adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition and all local codes and ordinances. The National Electric Code ...

Page 6 - Power Supply Cord; Style 1: Power supply cord strain relief

6 Electrical Connection Power Supply Cord Direct Wire 1. Disconnect power. 2. Remove the hold-down screw and terminal block cover. 3. Install strain relief. Style 1: Power supply cord strain relief ■ Remove the screws from a ³⁄₄ " (1.9 cm) UL listed strain relief (UL marking on strain relief). P...

Page 7 - Go to Section

7 ■ Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point. Sty...

Page 8 - Connect ground wire (green or bare) of power supply cord to; Connect the other wires to outer terminal block screws.; Remove neutral ground wire from external ground conductor

8 3. Connect ground wire (green or bare) of power supply cord to external ground conductor screw. Tighten screw. 4. Connect the other wires to outer terminal block screws. Tighten screws. 5. Tighten strain relief screws. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cov...

Page 10 - Optional 3-wire connection

10 2. Place the hooked end of the neutral wire (white or center wire) of power supply cable under the center screw of terminal block (hook facing right). Squeeze hooked end together. Tighten screw. 3. Place the hooked ends of the other power supply cable wires under the outer terminal block screws (...

Page 11 - Venting Requirements; If using an existing vent system; Fire Hazard

11 Venting Requirements WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED OUTDOORS. IMPORTANT: Observe all governing codes and ordinances. The dryer exhaust must not be connected into any gas vent, chimney, wall, ceiling or a concealed space of a building. If using an existing vent s...

Page 12 - Plan Vent System; Choose your exhaust installation type; Alternate installations for close clearances; Special provisions for mobile home installations; Determine vent path; Vent system chart; Install Vent System; Install exhaust hood. Use caulking compound to seal exterior; Connect vent to exhaust hood. Vent must fit inside exhaust

12 Plan Vent System Choose your exhaust installation type Recommended exhaust installations Typical installations vent the dryer from the rear of the dryer. Alternate installations for close clearances Venting systems come in many varieties. Select the type best for your installation. Two close-clea...

Page 13 - Excessive Weight Hazard

13 Install Leveling Legs 1. To protect the floor, use a large flat piece of cardboard from the dryer carton. Place cardboard under the entire back edge of the dryer. 2. Firmly grasp the body of the dryer (not the console panel). Gently lay the dryer on the cardboard. See illustration. 3. Start to sc...

Page 14 - DRYER USE; Starting Your Dryer; Clean the lint screen before each load. See “Cleaning the Lint; Turn the Cycle Control knob to the recommended cycle for; How Auto Moisture Sensing Works

14 DRYER USE Starting Your Dryer WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. Before using your dryer, wipe the dryer drum with a damp cloth to remove dust from storing and shipping. 1. Clean the li...

Page 15 - When using an air cycle; DRYER CARE; Cleaning the Dryer Location; Type of Load

15 Stopping and Restarting You can stop your dryer anytime during a cycle. To stop your dryer Open the dryer door or turn the Cycle Control knob to OFF. NOTE: The Cycle Control knob should point to an Off area when the dryer is not in use. To restart your dryer 1. Close the door. 2. Select a new cyc...

Page 16 - Cleaning the Lint Screen; Cleaning the Dryer Interior; Electrical Shock Hazard

16 Cleaning the Lint Screen Every load cleaning The lint screen is located inside the dryer drum, on the back wall. Clean it before each load. A screen blocked by lint can increase drying time. To clean 1. Open the door and pull the lint screen straight out. 2. Squeeze body of lint screen lightly wh...

Page 17 - TROUBLESHOOTING; Dryer Operation; Dryer will not run; Is the dryer door firmly closed?; No heat; Dryer Results

17 TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call... In U.S.A. www.whirlpool.com/help - In Canada www.whirlpool.ca Dryer Operation Dryer will not run ■ Has a household fuse blown...

Page 18 - Was the load removed from dryer at the end of the cycle?; Odors

18 ■ Are fabric softener sheets blocking the grille? Use only one fabric softener sheet, and use it only once. ■ Is the exhaust vent the correct length? Check that the exhaust vent is not too long or has too many turns. Long venting will increase drying times. See the Installation Instructions. ■ Is...

Page 19 - ASSISTANCE OR SERVICE; If you need replacement parts; Our consultants provide assistance with:; For further assistance; ACCESSORIES; Accessory

19 ASSISTANCE OR SERVICE Before calling for assistance or service, please check “Troubleshooting.” It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchase date and the complete model and serial number of your appliance...

Page 20 - WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY; ONE YEAR LIMITED WARRANTY; Any food loss due to refrigerator or freezer product failures.; DISCLAIMER OF IMPLIED WARRANTIES LIMITATION OF REMEDIES

WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter “Whirlpoo...

Whirlpool W10151595A - Manual

Table of Contents:

Summary

Other Whirlpool Models