Wet Sounds SYN DX 4 - User Manual
Wet Sounds SYN DX 4 Amplifier – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNING; your state has laws governing the volume of an audio system.; Please be aware; the exact locations you wish to install in.; WET SOUNDS SYN-DX SERIES AMPLIFIERS
- Page 3 – INSTALLATION INSTRUCTIONS; receives sufficient airflow for proper heat dissipation.; SUPPLYING ENOUGH POWER; professional technician.
- Page 4 – RUNNING THE WIRING CABLES; possibility of inducing noise into the system**; AMPLIFIER CONNECTIONS; Power Connections; REMOTE CONNECTION
- Page 5 – On the SYN-DX 6, there are 2 different input selection switches.
- Page 6 – SPEAKER TERMINAL INPUTS; POWER INDICATOR; diagnostic sequence.; See troubleshooting section for further detail.
- Page 8 – AMP DIAGRAM WITH LEGEND
- Page 10 – TROUBLESHOOTING; Check your fuse and replace if necessary.; If you are experiencing problems with your amplifier after; Wet Sounds SYN-DX Fault Codes
- Page 12 – SAMPLE SYSTEM SETUPS
- Page 14 – SPECS
- Page 18 – USA
2
4
6
HIGH PERFORMA
NCE MA
RINE A
UDIO
S Y N - D X
S E R I E S
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 CONGRATULATIONS! Thank you for purchasing the Wet Sounds SYN-DX series amplifier. Wet Sounds represents the ultimate in High Performance Marine Audio. Wet Sounds SYN-DX Series Marine Amplifiers are designed to be a complete solution for every type of extreme marine application. SYN-DX amplifiers u...
2 Wet Sounds SYN-DX Series Owner’s Manual INSTALLATION INSTRUCTIONS Wet Sounds Marine Amplifiers are designed for easy installation in your boat. To ensure proper installation of your new purchase please follow all the suggestions listed below. If you do not have experience with marine electrical an...
3 RUNNING THE WIRING CABLES **Always keep the signal cable and the power cables separated to prevent the possibility of inducing noise into the system** Carefully run the power and the signal cables through the boat. Always keep all the wire tight and tied down to prevent the power wire from shortin...
