Wet Sounds HTX 4 - User Manual

Wet Sounds HTX 4

Wet Sounds HTX 4 Amplifier – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
Page: / 19

Table of Contents:

  • Page 2 – Thank you for purchasing the Wet Sounds Hydro-Tech; the Wet SoundsTM products.; WARNING; your state has laws governing the volume of an audio system.; Please be aware; the exact locations you wish to install in.; WET SOUNDS HTX SERIES SUBWOOFER AMPLIFIERS
  • Page 3 – INSTALLATION INSTRUCTIONS; receives sufficient airflow for proper heat dissipation.; SUPPLYING ENOUGH POWER; professional technician.
  • Page 4 – RUNNING THE WIRING CABLES; possibility of inducing noise into the system**; AMPLIFIER CONNECTIONS; Power Connections; HTX Series; is designed for
  • Page 5 – There are 2 different input selection switches.; The first is to designate 2 or 4
  • Page 6 – SPEAKER TERMINAL INPUTS; POWER INDICATOR; diagnostic sequence.; See troubleshooting section for further detail.
  • Page 8 – AMP DIAGRAM WITH LEGEND
  • Page 10 – TROUBLESHOOTING; Check your fuse and replace if necessary.; If you are experiencing problems with your amplifier after; Wet Sounds HTX Fault Codes
  • Page 11 – mode, then both speakers will play in mono and not stereo.; Two dual male RCA Y-Splitters are; BRIDGED AUDIO RCA CONFIGURATION
  • Page 12 – SAMPLE SYSTEM SETUPS
  • Page 14 – SPECS
  • Page 19 – USA
Loading the manual

1

2

4

6

HIGH PERFORMA

NCE MA

RINE A

UDIO

H T X

S E R I E S

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Thank you for purchasing the Wet Sounds Hydro-Tech; the Wet SoundsTM products.; WARNING; your state has laws governing the volume of an audio system.; Please be aware; the exact locations you wish to install in.; WET SOUNDS HTX SERIES SUBWOOFER AMPLIFIERS

1 CONGRATULATIONS! Thank you for purchasing the Wet Sounds Hydro-Tech TM X (HTX) series amplifier. Wet Sounds represents the ultimate in High Performance Marine Audio. Wet Sounds HTX Series Marine Amplifiers are designed to be a complete solution for every type of extreme marine application. HTX amp...

Page 3 - INSTALLATION INSTRUCTIONS; receives sufficient airflow for proper heat dissipation.; SUPPLYING ENOUGH POWER; professional technician.

2 Wet Sounds HTX Series Owner’s Manual INSTALLATION INSTRUCTIONS Wet Sounds Marine Amplifiers are designed for easy installation in your boat. To ensure proper installation of your new purchase please follow all the suggestions listed below. If you do not have experience with marine electrical and m...

Page 4 - RUNNING THE WIRING CABLES; possibility of inducing noise into the system**; AMPLIFIER CONNECTIONS; Power Connections; HTX Series; is designed for

3 RUNNING THE WIRING CABLES **Always keep the signal cable and the power cables separated to prevent the possibility of inducing noise into the system** Carefully run the power and the signal cables through the boat. Always keep all the wire tight and tied down to prevent the power wire from shortin...

Other Wet Sounds Amplifiers Models