Page 2 - Conditions of Use; CONTENTS; WARNING; WARNING; CAUTION; ENVIRONMENTAL TIPS; ENVIRONMENT
2 CONTENTS Dear customer, Congratulations and thank you for choosing our cooktop. We are sure you will find your new cooktop a pleasure to use and a great asset to your cooking. Before you use the cooktop, we recommend that you read through the whole user manual which provides the description of the...
Page 3 - IMPORTANT; IMPORTANT SAFETY INSTRUCTIONS
3 IMPORTANT SAFETY INSTRUCTIONS Please read the user manual carefully and store in a handy place for later reference. TIPS & INFORMATION IMPORTANT Important – check for any damages or marks. If you find the cooktop is damaged or marked, you must report it within 7 days if you wish to claim for d...
Page 4 - INSTALLATION; USING YOUR COOKTOP
4 INSTALLATION INSTALLATION WARNING CAUTION You must read these warnings carefully before installing or using the cooktop. If you need assistance, contact our Customer Care Department. The manufacturer will not accept liability, should the instructions below or any other safety instructions incorpor...
Page 5 - CARE AND CLEANING
5 CLEANING AND CARE Choice of burners For your convenience there is a choice of burners: • A small burner for special low heat and slow cooking. • A medium burner for normal cooking and simmering. (one on 4-burner models and two on 5-burner models). • A large burner for fast heating and large pots a...
Page 6 - TROUBLESHOOTING
6 TROUBLESHOOTING TROUBLESHOOTING FAULT POSSIBLE CAUSES REMEDY Burner will not light even though the sparker is working. • Knob not held down long enough in ‘High’ position for flame safeguard (where fitted) to engage • Repeat lighting procedure and hold knob down for 5 seconds in ‘High’ position (r...
Page 7 - TECHNICAL DATA
7 TECHNICAL DATA FEATURES WHG642SA WHG644SA WHG646SA WHG646WA Cooking zones 4 4 4 4 Wok Yes Yes Yes Yes Ignition 220-240V 220-240V 220-240V 220-240V Trivet Wire Wire Cast Cast Hob material Stainless steel Stainless steel Stainless steel Toughened Glass Features Ignition through knob Ignition through...
Page 9 - INSTALLATION INSTRUCTIONS
9 NOTE: Distances shown to adjacent walls/surfaces are for the distance to a combustible surface. If the surface is not combustible the measurement can be smaller than that shown. Figure 4 - Installation cut-outs C B D min A min INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS MODEL CODE DIMENSIO...
Page 10 - INSTALLATION PROCEDURE
10 INSTALLATION PROCEDURE 1. The bench cutout should be made as per cutout dimensions in Figure 4. 2. Adjacent walls, cupboards and protection for combustible materials. Ensure that the appliance is installed in accordance with clauses 6.2.5 and 6.10.1.1 of AS/NZS 5601.1, or clauses 6.9.1 and 6.9.5 ...
Page 12 - GAS CONNECTION; Supply pipe sizing
12 GAS CONNECTION OPERATION ON N.G./S.N.G. GAS CONNECTION WARNING CAUTION This appliance is supplied for use with Natural Gas. However, it can be converted for use with LPG. Refer to LP conversion on pages 12 and 13. Supply pipe sizing The total hourly gas consumption for the appliance is shown on t...
Page 14 - To convert to LPG; LPG CONVERSION - DONG YANG REGULATOR
14 LPG CONVERSION Insert oriented for natural gas operation Insert oriented for LPG operation Figure 10 TIPS & INFORMATION IMPORTANT Refer to page 15 if you have been supplied with a CHANT regulator.This appliance is fitted with Natural Gas burner injectors. Please follow the procedure below if ...
Page 15 - LPG CONVERSION - CHANT REGULATOR
15 LPG CONVERSION TIPS & INFORMATION IMPORTANT Refer to page 14 if you have been supplied with a DONG YANG regulator. This appliance is supplied set up for Natural Gas usage. A conversion kit is included with the product for Universal LPG usage. The conversion kit contains the appropriate inject...
Page 16 - Use of Hose Assemblies
16 ELECTRICAL CONNECTION ELECTRICAL CONNECTION (220-240 VOLTS) The appliance is supplied with a standard 7.5Amp service cord terminated by a 3-pin plug for connection to a standard household socket. The electrical supply is required to power the electronic ignition system. NOTE: It will be necessary...
Page 17 - TESTING APPLIANCE OPERATION
17 TESTING APPLIANCE OPERATION After installation, test the appliance and ensure that it operates correctly before handing it over to the customer. The following procedure is recommended: 1. Turn on the gas and electricity supply and attempt ignition on all burners, both separately and in combinatio...
Page 19 - Warranty; Important Notice
19 WARRANTY This document sets out the terms and conditions of the product warranties for Electrolux Appliances. It is an important document. Please keep it with your proof of purchase documents in a safe place for future reference should you require service for your Appliance. 1. In this warranty: ...
Page 20 - TOP SERVICE
AUSTRALIA phone: 1300 363 640fax: 1800 350 067 email: [email protected]web: www.westinghouse.com.au NEW ZEALAND phone: 0800 436 245fax: 0800 225 088 email: [email protected]web: www.westinghouse.co.nz For more information on all Westinghouse appliances, or for dimension and installation information,...