VocoPro UHF-8800 - Manual

5 CAUTION RISK OF SHOCK CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Only refer servicing to qualified service personnel. WARNING To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. Explanation ...

And thank you for purchasing the UHF-8800 from VocoPro, your ultimate choice in Karaoke entertainment! With years of experience in the music entertainment business, VocoPro is a leading manufacturer of Karaoke equipment, and has been providing patrons of bars, churches, schools, clubs and individual...

7 Specifications Receiver Oscillation Mode: Quartz Controlled Fixed Frequency Stability: 10 PPM Sensitivity: 1.6uV @ sinad =12dB Max. Deviation Range: 50Hz S/N Ratio:>105dB T.H.D.: <0.5% @ 1kHz Image rejection: 85dB typical Spurious Rejection: 75dB typical Frequency Response: 40Hz~16kHz Squelch...

8 Thank you for purchasing the UHF-8800. Take a few moments to look through this manual. Before setting up, please make sure the following items are included. • UHF-8800 • 8 Wireless Mics • Carrying Case • Power Adapter Returns and Warranty In the unlikely event that the UHF-8800 would need to be sh...

9 Microphone Basics Microphone Position The UHF-8800 is ideal for close-up vocals and can be held in the hand or mounted on a mic stand. The most common applications and placement techniques are listed below. Keep in mind that microphone technique is largely a matter of personal taste, and there is ...

10 To install the UHF-8800 to a 19” rack case, complete the steps below. 1. Align the UHF-8800 with the desired space in rack and slowly slide in, rear panel first. 2. While aligned, use rack case screws (not included) in the order shown below to stabilize the UHF-8800 in its space, using the “X” ro...

11 Getting Connected System Connection 1. Connect the AC POWER ADAPTER to the UHF-8800 receiver’s POWER INPUT connector, then plug the ADAPTER into a compatible AC electrical outlet. 2. Connect the UHF-8800’s receiver to a sound system, mixer or amplifier’s microphone input(s) with either two ¼” out...

12 1. ANTENNAS - Provide both RF and AF signals. 2. POWER (LED) - Indicates whether the UHF-8800 is ON or OFF. When it is lit, the power is ON. 3. RF (LED) - Lights when RF signals are received from the microphone channels. 4. AF (LED) - Lights when AF signals are received from the microphone channe...

13 Maintenance Procedures Handheld Microphone Battery Installation 1. To remove the lid, press down on the tab and slide the lid down towards the bottom of the mic. 2. Insert 2 fresh 1.5-volt AA alkaline batteries. Make sure the batteries are inserted in the right direction according to polarity (+/...

14 UHF-8800 & stage monitor/p.a. loudspeakers If you will be using the UHF-8800 with stage monitors and/or P.A. system, try the following: • Place the stage monitor directly behind the microphone. • Locate the P.A. loudspeakers so that they point away from the rear of the microphone. (With the s...

15 Troubleshooting Problems No sound output, RF/AF LED(s) are not glowing Received signal is noisy or contains extraneous sounds with the microphone(s) ON. There is noise coming from the receiver with the microphones turned OFF. Momentary loss of sound as microphone(s) are moved throughout the opera...