VocoPro UHF-5805 - Manual

5 Selecting fine audio equipment such as the unit you’ve just purchased is only the start of your musical enjoyment. Now it’s time to consider how you can maximize the fun and excitement your equipment offers. VocoPro and the Electronic Industries Association’s Consumer Electronics Group want you to...

6 Specifi cations Receiver Oscillation Mode: Quartz Controlled Fixed Frequency Stability: 10 PPM Sensitivity: 1.6uV @ sinad =12dB Max. Deviation Range: 50Hz S/N Ratio:>105dB T.H.D.: <0.5% @ 1kHz Image rejection: 85dB typical Spurious Rejection: 75dB typical Frequency Response: 40Hz~16kHz Squelc...

7 Microphone basics Microphone Position The UHF-5805 is ideal for close-up vocals and can be held in the hand or mounted on a mic stand. The most common applications and placement techniques are listed below. Keep in mind that microphone technique is largely a matter of personal taste, and there is ...

8 Before getting started Before starting any installation procedures, it is recommend to completely unpack all the package contents. The original packaging should be kept in the event that re-shipping is needed. Upon unpacking the UHF-5805, you should have received the following items: • Custom Alum...

9 To install the UHF-5805 to a 19” rack case, complete the steps below. 1. Attach mounting brackets to the UHF-5805 via the supplied mounting screws. 2. Align the UHF-5805 with the desired space in rack and slowly slide in, rear panel first. 3. While aligned, use rack case screws (not included) in t...

10 Getting Connected System Connection 1. Connect the AC POWER ADAPTER to the UHF-5805 receiver’s POWER INPUT connector, then plug the ADAPTER into a compatible AC electrical outlet. 2. Connect the UHF-5805’s receiver to a sound system, mixer or amplifier’s microphone input(s) with either one ¼” out...

11 Maintenance procedures Removing the Field Replaceable Modules Each of the 4 microphone modules on the UHF-5805 were designed in a way that allows them to slide out. This is a convenient feature if ever a module needs to be repaired or replaced. 1. Remove the two screws that fasten the module to t...

12 The UHF-5805 comes with two dual chargers that let you charge all four microphones at the same time. Charging the Microphones If the LED light on the microphone(s) does not light up when the microphone is turned on, this indicates that the microphone needs to be charged To charge: 1. Place the mi...

13 Front and rear panel descriptions and functions 1. ANTEN ANTE ANTE NAS N N - P NAS NAS rovide both RF and AF signals. 2. POWER (LED) - Indicates whether the UHF-5805 is ON or OFF. When it is lit, the power is ON. 2. POWER (LED) 2. POWER (LED) 3. RF (LED) - Lights when RF signals are received from...

14 UHF-5805 & stage monitor/p.a. loudspeakers If you will be using the UHF-5805 with stage monitors and/or P.A. system, try the following: • Place the stage monitor directly behind the microphone. • Locate the P.A. loudspeakers so that they point away from the rear of the microphone. (With the s...

15 Troubleshooting Problems No sound output, RF/AF LED(s) are not glowing Received signal is noisy or contains extraneous sounds with the microphone(s) ON. There is noise coming from the receiver with the microphones turned OFF. Momentary loss of sound as microphone(s) are moved throughout the opera...