Page 2 - L i m i t e d L i f e t i m e
i © 2006 Directed Electronics—all rights reserved L i m i t e d L i f e t i m e C o n s u m e r Wa r ra n t y Directed Electronics promises to the original purchaser to repair or replace with acomparable reconditioned model any Directed Electronics unit (hereafter the "unit"),excluding witho...
Page 3 - ii
ii © 2006 Directed Electronics—all rights reserved HEREBY EXPRESSLY DISCLAIMS ANY LIABILITY WHATSOEVER, INCLUDINGWITHOUT LIMITATION, LIABILITY FOR THEFT, DAMAGE AND/OR VANDALISM. THISWARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REIN-STALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMA...
Page 4 - Ta b l e of C o n t e n t s
1 © 2006 Directed Electronics—all rights reserved Ta b l e of C o n t e n t s Limited Lifetime Consumer Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . i Standard Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 What is Included . . . . . . . . . ....
Page 5 - S t a n d a rd C o n f i g u ra t i o n
2 © 2006 Directed Electronics—all rights reserved S t a n d a rd C o n f i g u ra t i o n controls the Arm/Panic ON/Panic OFF function. controls the Disarm function. controls Silent Mode™ and an Auxiliary Output . controls Remote Start . + controls Timer mode. + controls Turbo/Short Run . + controls...
Page 6 - W h a t i s I n c l u d e d
3 © 2006 Directed Electronics—all rights reserved W h a t i s I n c l u d e d ■ The control module ■ A Venom SST receiver/antenna ■ Two four-button transmitters ■ The blue status LED indicator light ■ A push-button Valet button ■ Your warranty registration ■ A shut-down toggle switch I m p o r t a n...
Page 7 - Your Warranty
4 © 2006 Directed Electronics—all rights reserved The system requires no specific maintenance. Your remote is powered by two small, lightweight 3-volt lithium batteries that will last approximately one year under normal use. When the battery begins to weaken, operating range will be reduced and the ...
Page 8 - from the person’s body, except for the hand and wrists, to satisfy RF; Caution
5 © 2006 Directed Electronics—all rights reserved and its antenna must maintain a separation distance of 20 cm or more from the person’s body, except for the hand and wrists, to satisfy RF exposure compliance. This device is designed to be used in a person’s hands and its operating configurations do...
Page 9 - Tra n s m i t t e r F u n c t i o n s; Button; Standard Configuration
6 © 2006 Directed Electronics—all rights reserved Tra n s m i t t e r F u n c t i o n s The receiver uses a computer-based learn routine to learn the transmitter buttons. This makes it possible to assign any specific transmitter button, or combination of buttons, to any receiver function. The transm...
Page 10 - Buttons; Us i n g Yo u r S ys t e m; Warning! Safety First
7 © 2006 Directed Electronics—all rights reserved The remote start function of your system is controlled by pressing this button twice within 3 seconds. and Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing these but- tons...
Page 11 - THE USER MUST INSTALL A CARBON MONOXIDE DETECTOR
8 © 2006 Directed Electronics—all rights reserved When parking in an enclosed or partially enclosed area or when having the vehicle serviced, the remote start system must be disabled using the installed toggle switch. It is the user's sole responsibility to properly handle and keep out of reach from...
Page 12 - Arming
9 © 2006 Directed Electronics—all rights reserved module by performing the Safety Check outlined in the prod- uct installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must be...
Page 13 - Disarming
10 © 2006 Directed Electronics—all rights reserved Starter Kill automatically (called Passive Mode). If the system has been programmed for Passive Mode, the Failsafe ® Starter Kill will automatically activate 30 seconds after the ignition has been turned off. After the ignition has been turned off, ...
Page 14 - LOCATION OF VALET BUTTON; Valet Mode
11 © 2006 Directed Electronics—all rights reserved If your remote transmitter is lost or damaged, you can manually override the starter kill. To do this, you must have the vehicle's ignition key and know where the Valet button is located. Be sure to check with the installer for the location of the V...
Page 15 - To enter or exit Valet Mode:; Panic Mode
12 © 2006 Directed Electronics—all rights reserved To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet button within 10 seconds. The status LED will light steadily if you are entering Valet Mode and will turn off if you are exiting Valet Mod...
Page 16 - To remote start the vehicle:; Remote Start
13 © 2006 Directed Electronics—all rights reserved This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehi- cle with the climate control system. If interior ...
Page 17 - When you are ready to drive the vehicle:; Rear Defogger
14 © 2006 Directed Electronics—all rights reserved When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the ON (not the START) position. 2. Press the brake pedal. NOTE: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. While ...
Page 19 - Timer Mode
16 © 2006 Directed Electronics—all rights reserved Short-run turbo mode keeps the engine running after arriving at you destination for a programmable period of 1, 3 ,5 or 10 min- utes. This allows the system’s timer to conveniently cool down the turbo after you have left the vehicle. To activate: 1....
Page 20 - Timer Mode should be used only; important; Timer Mode should be used only in
2. The vehicle will confirm with 4 parking light flashes. 3. A 1-second delay will start. 4. The system will start the car and will run for the specified duration, unless shut down by the remote start button . If shut down with the remote start button the system will remain in timer mode. 5. The sys...
Page 21 - LOCATION OF SHUTDOWN SWITCH; Disabling the Remote Start System
18 © 2006 Directed Electronics—all rights reserved Whenever the vehicle is remote started, advanced anti-grind cir- cuitry prevents the starter from engaging, even if the key is turned to the start position. This prevents damage to the starter motor if the key is turned to the start position during ...
Page 22 - R a p i d R e s u m e L o g i c; bold
19 © 2006 Directed Electronics—all rights reserved R a p i d R e s u m e L o g i c This Directed Electronics system will store its current state to non- volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. This means if the unit is in Valet Mode...
Page 23 - flashing
20 © 2006 Directed Electronics—all rights reserved ■ Comfort closure is a programming option which closes the vehicle’s windows after remote locking. ■ Parking lights flashing or constant. Your system can be pro- grammed to either flash or to turn on the parking lights con- stantly during the entire...
Page 24 - G l o s s a r y of Te r m s; Control Unit
21 © 2006 Directed Electronics—all rights reserved G l o s s a r y of Te r m s Control Unit : The “brain” of your system. Usually hidden under- neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all system functions. Failsafe ® Starter Kill: An ...
Page 25 - C o n ve n i e n c e E x p a n s i o n s; Domelight Supervision:
22 © 2006 Directed Electronics—all rights reserved C o n ve n i e n c e E x p a n s i o n s Listed below are some of the many expansion options available for use with your system. Some options may require additional parts and/or labor. Please consult with your dealer for a complete list of options a...
Page 26 - Power Window Control:
23 © 2006 Directed Electronics—all rights reserved Power Window Control: Power window control is provided with Directed Electronics 529T or 530T systems. The 529T system will roll up two windows automatically when the system is armed, or roll two windows down by using the transmitter. The 530T will ...
Page 27 - N o t e s
24 © 2006 Directed Electronics—all rights reserved N o t e s
Page 28 - Q u i c k R e f e re n c e G u i d e
25 © 2006 Directed Electronics—all rights reserved Q u i c k R e f e re n c e G u i d e To arm using your remote ■ To arm the system press for one second. The doors will lock (if con- nected). The LED will begin to flash. The vehicle’s horn (if connected)will honk and the parking lights will flash o...
Page 29 - Valet Takeover; Rear Window Defogger
Cut along dotted line and f old f o r a quick and eas y r efer ence to k eep in y our pur se or w allet. ✂ ✂ Valet Takeover ■ Press and release on the transmitter twice in 3 seconds. Turn the ignition key to the OFF position. Once the vehicle has started, it will runfor the pre-programmed period of ...
Page 30 - The company behind this system is Directed Electronics
The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumerswith the finest vehicle security and car stereo products and accessories available. Therecipient of nearly 100 patents and Innovations Awards in the field of adva...
