Page 2 - ii
ii © 2005 Directed Electronics—all rights reserved LL ii m m ii tt ee d d LL ii ff ee tt ii m m ee CC o o n n ss u u m m ee rr W W aa rr rr aa n n tt yy Directed Electronics promises to the original purchaser to repair or replace with acomparable reconditioned model any Directed Electronics unit (he...
Page 3 - iiii
iiii © 2005 Directed Electronics—all rights reserved W WH HA ATTSSO OEEV VEER R,, IIN NCCLLU UD DIIN NG G W WIITTH HO OU UTT LLIIM MIITTA ATTIIO ON N,, LLIIA AB BIILLIITTY Y FFO OR R TTH HEEFFTT,, D DA AM MA AG GEE A AN ND D//O OR R V VA AN ND DA ALLIISSM M.. TTH HIISS W WA AR RR RA AN NTTY Y D DO O...
Page 9 - Waarrn
6 6 © 2005 Directed Electronics—all rights reserved B Bu utttto on n The remote start function of your system is controlled by pressing this button twice within 3 seconds. and Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by press...
Page 11 - Arrm
8 8 © 2005 Directed Electronics—all rights reserved module by performing the Safety Check outlined in the prod- uct installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been properly installed. The remote start module must ...
Page 12 - Diissaarrm
9 9 © 2005 Directed Electronics—all rights reserved been programmed for Passive Mode, the Failsafe ® Starter Kill will automatically activate 30 seconds after the ignition has been turned off. After the ignition has been turned off, the status LED will flash rapidly to indicate that the system is in...
Page 14 - Paan
1 11 1 © 2005 Directed Electronics—all rights reserved TTo o een ntteerr o orr eexxiitt V Vaalleett M Mo od dee:: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the Valet button within 10 seconds. The status LED will light steadily if you are entering Valet Mode and will tur...
Page 15 - Reem
1 12 2 © 2005 Directed Electronics—all rights reserved This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehi- cle with the climate control system. If inter...
Page 16 - Reeaarr D
1 13 3 © 2005 Directed Electronics—all rights reserved W Wh heen n yyo ou u aarree rreeaad dyy tto o d drriivvee tth hee vveeh hiiccllee:: 1. Insert the ignition key and turn it to the ON (not the START) position. 2. Press the brake pedal. N NO OTTEE:: If the brake pedal is pressed before the key is...
Page 17 - Ovveerr
1 14 4 © 2005 Directed Electronics—all rights reserved To turn the rear defogger output ON: 1. Simultaneously press & release the + + buttons on the remote control. 2. The lights will flash 3 times. 3. The rear defogger output will once again activate when the vehicle is remote started. N NO OTT...
Page 19 - important; Timer Mode should be used only in
1 16 6 © 2005 Directed Electronics—all rights reserved 2. The vehicle will confirm with 4 parking light flashes. 3. A 1-second delay will start. 4. The system will start the car and will run for the specified duration, unless shut down by the remote start button . If shut down with the remote start ...
Page 23 - G ll o
2 20 0 © 2005 Directed Electronics—all rights reserved G G ll o o ss ss aa rr yy o o ff TT ee rr m m ss CCo on nttrro oll U Un niitt: The “brain” of your system. Usually hidden under- neath the dash area of the vehicle. It houses the microprocessor which monitors your vehicle and controls all system...
Page 26 - otteess
2 23 3 © 2005 Directed Electronics—all rights reserved N No otteess