Vermont Casting RDVOD - Manual

Table of Contents:

• Page 2 – Radiance Direct Vent /Natural Vent Gas Heater; Completion of sale, nor for purpose of resale,; Installation & Operating Instructions
• Page 3 – Radiance Direct Vent/Natural Vent Gas Heater; Radiance Direct Vent/Natural Vent Stove Dimensions; Attention
• Page 4 – Installation Requirements; Locating The Stove; Possible stove locations.; Direct Vent System Only; Stardance; Clearance Requirements; Minimum Clearances to Combustible Materials
• Page 5 – Parallel installation, minimum back and side clear-; Corner installation, minimum corner clearances and; Minimum wall centerline.; Sidewall Clearance; Direct Vent Only
• Page 6 – Radiance Direct Vent/Natural Vent; Input; Gas Inlet and Manifold Pressures; ment, alteration, service or maintenance; Horizontal Termination -
• Page 7 – Vent Termination Clearances; NOTE: The restrictor; Vertical vent termination window.; IMPORTANT
• Page 9 – General Venting Information - Termination Location; Canadian Installations
• Page 10 – Venting Runs; (Measured from top of the unit before any elbow); NOTE: When venting staight vertical, without any; Termination Clearances; Termination clearances.; Venting Requirements - Natural Vent Only; Vent termination window - Natural Vent ONLY.
• Page 11 – Venting Requirements and Options -; Approved Vent System Components; Simpson DuraVent Components; Direct vent pipe may be used on the Natural
• Page 12 – Slide stove back just far enough to access rear leg; Assembly Procedures; Failure to position the parts in accor-; WARNING; Tools Required; Radiance; Carefully tip stove onto back legs. Leave pallet under
• Page 13 – JUV; Attach the fan rheostat.; Install the Optional Fan; Remove rear shroud.; Fan kit components.; Attach blower assembly and snapstat.
• Page 14 – Venting System Assembly - Direct Vent; For Canadian installations:; Install the Vent Adapter Pipe; Install the restrictor plate only if required for the vent-; Attach the Inner Vent Assembly to the stove.; attach inner pipe; Connect the inner starter with the next section of; attach inner assy
• Page 15 – Side Wall Termination Assembly; Discard the inner starter pipe; install outer adpater; dura vent; Simpson DuraVent - install inner adpater pipe.; Vent Opening; Combustible Wall; Locate vent opening.; CFM System
• Page 16 – For DuraVent pipe only:; Zero Clearance Sleeve; Assemble the wall sleeve and firestop.; measure thru wall; Measure the horizontal length.; install pipe thru wall; Install the horizontal pipe and wall plate parts.
• Page 17 – Vent Assembly; install snorkel; Snorkel kit installation.; Vent Termination Below Grade; If the; snorkel detail; Use extension brackets to mount snorkel against; install wall terminal; Install the vent terminal.
• Page 18 – vent thru roof; Roof support and flashing.; Venting System Assembly - Natural Vent; Install firestops and attic insulation shield.
• Page 19 – Install Log Set; Remove the stove front.; Release the latches to remvoe the glass frame.; Install the Vent Pipe; attach draft hood
• Page 20 – Install the left and right rear logs and the right log.; Install the right log by engaging hole on the bottom; Connect the Gas Supply Line; Gas connection should be made in ac-; Radiance logs; Completed log installation.; Top View; Lava rock placement.; Radiance logs
• Page 21 – Use only a thermostat rated for 500 - 750 millivolts.; Install ON/OFF Switch; PILOT; attach switch; Attach switch wires to valve.; Install the Mesh and Grille; THIS APPLIANCE SHOULD BE CON-; In order to connect Natural Gas,; CAUTION; attach switch assy; Attach switch assembly to rear shroud.; Thermostat
• Page 22 – Operation; Your First Fire; handle holder; When not in use, store handle in the handle holder.; Pilot Assembly location.; To open the front doors, turn handle counterclockwise.; Flame & Temperature Adjustment; Flame adjustment knob for Honeywell valve.; Flame Characteristics; Correct pilot and burner flame patterns.; Pilot flame; SIT Pilot
• Page 23 – FOR YOUR SAFETY READ BEFORE LIGHTING; WHAT TO DO IF YOU SMELL GAS; To Turn Off Gas To Heater; Lighting and Operating Instructions; Lighting Instructions; Lighting instructions
• Page 24 – Troubleshooting / Honeywell #8420 Gas Control System; SYMPTOM
• Page 25 – comfort valve; Transmitter diagram.; Honeywell; Comfort control valve.
• Page 26 – Local Path
• Page 27 – above; Auto Path; below
• Page 28 – If an Error Code 3 is observed while performing the; Blower; Comfort Valve wiring diagram.
• Page 29 – All Models; Depress and turn center plunger.; Model; RDVOD, RDVOD with; Table 2. Air Shutter Adjustment; Remove and replace injector orifices.; injector orifice; Conversion to Natural Gas; Table 1. Injector Orifice Size Matrix
• Page 30 – Maintenance; painted surfaces; Remove the Stove Front.
• Page 31 – Gasket Replacement; Determine the correct length of gasket by laying it; Inspect the Vent System Annually; glass gasket detail; Wrap the gasket material around the outside edge of; Correct flame pattern.; Release the latches to remove the glass frame.
• Page 32 – BLK; rdv connections diag.; Schematic Diagram; Wiring Diagrams; On/off switch and optional thermostat circuit.; Used on
• Page 33 – RDVOD; Manifold Assembly
• Page 35 – Fuel Conversion Kits
• Page 36 – Optional Accessories; Fan Kits
• Page 37 – BASIC WARRANTY; COMPONENT WARRANTY; IF WARRANTY SERVICE IS NEEDED...; ) Contact your supplier. Make sure you have your warranty,; LIMITED LIFETIME WARRANTY; PRODUCT COVERED BY THIS WARRANTY
• Page 38 – Efficiency Ratings; RDVODRN; CFM Corporation