Vector VEC1095A - Manual
Vector VEC1095A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PERSONAL PRECAUTIONS AND SAFETY; ponents and may cause explosion.; POWER CORD CONNECTION; FIGURE 1; METAL SCREW
- Page 3 – NEVER; DC CONNECTION PRECAUTIONS
- Page 4 – NOTE
- Page 5 – INTRODUCTION AND FEATURES; FIGURE 2 - CHARGE CURVE; FEATURES
- Page 6 – FIGURE 3A; CONTROLS AND INDICATORS; C h a r g e R a t e S e l e c t o r ( S t e p 2 )
- Page 7 – CHARGE RATE SELECTION; It can indicate alternator service may be required.; INDICATORS
- Page 9 – the LED display is showing “000” or a circulating pattern.; ing and let the battery cool.
- Page 10 – The Digital Display will begin a count down starting at 999 to 000; ably shorted, open or sulfated and should be replaced.
- Page 11 – PERCENT OF CHARGE; NR; WARNING: DO NOT ATTEMPT TO CHARGE A FROZEN BATTERY
- Page 12 – WARRANTY; TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT:; Contact Vector Manufacturing Technical Support by telephone,
SMART AUTOMATIC
BATTERY CHARGER
OWNER’S MANUAL & WARRANTY INFORMATION
12 VOLT 2/10/25 AMP WITH 75 AMP ENGINE START
ALTERNATOR VOLTAGE CHECK AND BATTERY RECONDITION
FUNCTIONS
• IMPORTANT SAFETY INSTRUCTIONS •
WARNING – RISK OF EXPLOSIVE GASES
WARNING - RISK OF EXPLOSIVE GASES
1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE
EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF
UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU READ THIS
MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
2. To reduce risk of battery explosion, follow these instructions and those published by the battery manufac-
turer and manufacturer of any equipment you intend to use in vicinity of battery. Review cautionary mark-
ings on these products and on engine.
GENERAL SAFETY
1.
Use this charger for charging a LEAD-ACID battery only. It is not intended to supply power to a low voltage electrical sys-
tem other than in a starter-motor application. DO not use this battery charger for dry-cell batteries that are commonly used
with home appliances. These batteries may burst and cause injury to persons and damage to property.
2.
Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric
shock, or injury to persons.
3.
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
4.
An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a
risk of fire and electric shock.
If extension cord must be used, make sure:
a. Pins on plug of extension cord are the same number, size, and shape as those of plug on charger.
b. Extension cord is properly wired and in good electrical condition; and
c. Wire size is AWG#14 (14 gauge) to 100 feet and AWG#12 for distances over 100 feet.
5.
Do not operate charger with damaged cord or plug - take to a qualified service technician for replacement of the cord or
plug immediately.
6.
Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in anyway; take it to a qual-
ified service technician.
7.
Do not disassemble charger; contact a qualified service technician when service or repair is required. Incorrect reassem-
bly may result in risk of electric shock or fire.
8.
To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off
charger controls will not reduce this risk.
9.
Do not operate charger in rain or snow or use when wet.
10. Never charge a frozen battery.
SAVE THESE INSTRUCTIONS:
This manual contains important safety and operating instructions for battery charger Model
VEC1095A
4140 SW 28TH WAY, FT. LAUDERDALE, FL 33312 • TEL: 954-584-4446 • FAX: 954-584-5556 • TOLL-
FREE 866-584-5504
VEC1095A
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
US Patent No. 6,822,425
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PERSONAL PRECAUTIONS AND SAFETY 1. Another person should be close enough to come to your aid when you work near a lead-acid battery.2. Fresh water and soap should be nearby in case battery acid contacts skin, clothing, or eyes.3. Wear eye protection and protective clothing. Avoid touching eyes or sk...
PREPARING TO CHARGE 1. Determine voltage of battery by referring to car owner's manual. 2. If necessary, remove battery from vehicle to charge, or to clean terminals, always remove grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc. 3. C...
FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED OUTSIDE VEHICLE. A SPARK NEARBATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY: 1. Check polarity of battery posts for top-mounted battery connectors, the Positive posts (marked POS,P, +) usually hasa larger diameter than the Neg...
