Turboair MSR-72G-3 - Manual

Page 2 - CONTENTS; Refrigerators; SPECIFICATION; The serial number is located on the data label inside.; SERIAL NUMBER; Freezers; MODEL

1. SPECIFICATION .......................................................................................... 2 2. SERIAL NUMBER ........................................................................................ 2 3. INSTALLATION .....................................................................

Page 3 - GOOD AIR CIRCULATION; weight of the cabinet and any other contents.; DO NOT PLACE NEAR HEAT; INSTALLATION

3 Turbo air 1. GOOD AIR CIRCULATION - Be sure to avoid any partition and object which may stop the air flow.- Be sure that air space is allowed to flow the rear of the unit. Turbo air recommends that the rear of the unit would be no less than 5 inches from thewall. 2. PLACE ON STRONG GROUND - Be sur...

Page 4 - CLEANING; CLEANING STAINLESS STEEL INTERIOR AND EXTERIOR (select models); recommended products is; NOT; CAUTION

4 Turbo air CLEANING 1. CLEANING STAINLESS STEEL INTERIOR AND EXTERIOR (select models) : Damage to stainless steel finish due to improper use of cleaning products or non- recommended products is NOT covered under this product's warranty. • DO NOT USE - Abrasive or harsh cleaners- Ammonia- Chlorine b...

Page 5 - BASIC OPERATION; REFRIGERATORS

5 Turbo air BASIC OPERATION MSR-23NM MSR-23G-1 MSR-49NM MSR-49G-2MSR-72G-3 1. Plug in and turn on the power switch located on the bottom of the top grille right side. The Display panel will be lighted and make a beep sound. The compressor will beginto run. 2. The default temperature setting is No. “...

Page 6 - DISPLAY PANEL OF REFRIGERATOR; QUICK COOLING

6 Turbo air DISPLAY PANEL OF REFRIGERATOR 9 TEMPERATURE Q.C. 8 7 6 5 4 3 2 1 FAN DOOR QUICK COOLING TEMPERATURE ˚F TEMP. SETTING QUICK COOLING FAN RUNNING DOOR OPENING QUICK COOLING BUTTON TEMP. CONTROL BUTTON (SEE TO PAGE 7) INNER TEMP. (SEE TO PAGE 8) (SEE TO PAGE 7)

Page 7 - return to the normal operation.

7 Turbo air 1. If you push the Q.C. (QUICK Cooling) button, the compressor will run continuously until D-Senser detect 14˚F (-10˚C) to bring down the temperature more quickly.(max.comp.run time = 120 min.) 2. If you push the Q.C. button again during QUICK Cooling mode, the compressor will return to ...

Page 8 - Evaporator fan motor is activated when the door is closed.; INNER TEMPERATURE DISPLAY

8 Turbo air 1. It displays the inside temperature. 2. Display range is 14˚F to 69˚F (-10˚C ~ +20˚C). 3. When the inside temperature is lower than 14˚F, the panel will display ‘ ’. and, higher than 69˚F, the panel will display ‘ ’. 1. If the fan motor is running, fan running indicator will be turned ...

Page 9 - Good Air Flow in freezer unit is critical.; FREEZERS

9 Turbo air BASIC OPERATION 1. Plug in and turn on the power switch located on the bottom of the top grille right side. The Display panel will be lighted and make a beep sound. The compressor will beginto run. 2. The default temperature setting is No. “5”. 3. The compressor is automatically cycled b...

Page 10 - DISPLAY PANEL OF FREEZER; MANUAL DEFROST

10 Turbo air DISPLAY PANEL OF FREEZER 9 TEMPERATURE D.F. 8 7 6 5 4 3 2 1 FAN DOOR MANUAL DEFROST TEMPERATURE ˚F TEMP. SETTING MANUAL DEFROST FAN RUNNING DOOR OPENING MANUAL DEFROST BUTTON TEMP. CONTROL BUTTON (SEE TO PAGE 11) INNER TEMP. (SEE TO PAGE 12) (SEE TO PAGE 11)

Page 11 - can not make the compressor cycle ON or OFF.

11 Turbo air 1. If you push MANUAL DEFROST button for 5 seconds, the Defrost will start. 2. During the Manual Defrost mode, the Up/Down button for the temperature control can not make the compressor cycle ON or OFF. 3. If you want to change the Manual Defrost mode to the normal mode, push MANUAL DEF...

Page 12 - When inside temperature is lower than -50 ̊F, the panel will display ‘ ’.

12 Turbo air 1. It displays inside temperature. 2. Display range is -50˚F to 50˚F (-45˚C ~ +10˚C). 3. When inside temperature is lower than -50˚F, the panel will display ‘ ’. and, higher than +50˚F, the panel will show ‘ ’. 1. If the fan motor is running, fan running indicator will be turned on. 2. ...

Page 13 - BEFORE REQUESTING SERVICE; SYMPTOMS; There is a loud noise.; The following points are not malfunctions:; • A water-flowing sound can be heard when the compressor stops.

13 Turbo air BEFORE REQUESTING SERVICE SYMPTOMS CAUSES SOLUTIONS Freezer is meltingfood. The unit does notrefrigerate at all. The unit does notrefrigerate well. There is a loud noise. There are dew-dropson the unit exterior. There are dew-dropson the unit interior. The door does notclose tightly. • ...

Page 14 - ONE YEAR WARRANTY

14 Turbo air MANUFACTURING COMPANY Turbo air warrants to the original purchaser of every new-Turbo air refrigerated unit, the cabinet and all parts thereof, to befree from defects in material or workmanship, under normal use and service, for a period of one (1) year from the date oforiginal installa...

Page 15 - WHAT IS NOT COVERED BY THIS WARRANTY

15 Turbo air WHAT IS NOT COVERED BY THIS WARRANTY Turbo air’s obligation under warranty is limited to either repair or replacement of parts, subject to the additional limitationsbelow. This warranty neither assumes nor authorizes any person to assume obligations other than expressly covered bythis w...

Turboair MSR-72G-3 - Manual

Table of Contents:

Summary

Other Turboair Models